3. PRECAUTIONS AND SAFETY INSTRUCTIONS BEFORE THE
INITIALSTART-UP
Your visi/cooler must be plugged certainly in an earthed wall
socket.
Before operating the visi/cooler, ensure that the mains socket is
checked for proper earthing (grounding) and nominal voltage and
frequency requirements by the authorized service staff or a qualified
electrician. If the supply cord is damaged, it must be replaced by the
manufacturer, oritsauthorizedserviceorasimilarlyqualifiedpersonin
ordertoavoidanyhazard.
Donotusemultisocketandextensioncable.
The main power supply to which the visi-cooler is connected
must have a leakage current relay.
The nominal voltage and frequency requirements for the body are
specifiedonthedataplate.
Never make any repairs or carry out maintenance while the
visi/coolerispluggedinthemainssocket.
Do not position the visi/cooler in a place, close to a source of strong
heat or exposed to direct sunlight.Always remember that the UV lights
in the sunlight deteriorates food in the glass door visi/coolers. The
appliancecanbeusedinambienttemperatureofmax.32°C.
Unlessotherwisestated, donotplace yourcoolerto openareaswhere
watercanleakin.
Donotwashwithpressurizedwaterorhosewhen cleaningtheproduct
and its surroundings, use a wet cloth. Otherwise, the water which may
intrudeinto theelectrical componentsoftheproduct cancause electric
shockandfirerisk.
Start the visi-cooler on a level surface. Position it on the floor and
make sure that it is level using a bubble gauge. If the visi-cooler is
found to tilt in one particular direction, please adjust the height of
the corresponding leg until it is level. Then please move the
visi/coolertothelocationwhereitwillbeused.
2
