Klipsch R5 User manual

1
R5 NECKBAND WIRELESS
OWNER’S MANUAL

2
TABLE OF CONTENTS
TABLE DES MATIèRES • CONTENIDO • INHALT • INDICE • SUMáRIO
4-5
6
7-9
10
11
12
12
12
13
13
14-15
16-17
18-31
32-45
46-59
60-73
74-87
88-101
102-115
- SAFETY INFORMATION [ENGLISH]
- OSHA GUIDELINES [ENGLISH]
- COMPLIANCE INFORMATION [ENGLISH]
- CONTROLS [ENGLISH]
- CONTROLS - VIBRATION [ENGLISH]
- GETTING STARTED [ENGLISH]
- TURNING OFF [ENGLISH]
- CHARGING [ENGLISH]
- ADDITIONAL FEATURES [ENGLISH]
- SPECIFICATIONS [ENGLISH]
- STATUS INDICATOR [ENGLISH]
- WARRANTY [ENGLISH]
[FRENCH]
[SPANISH]
[GERMAN]
[ITALIAN]
[PORTUGUESE]
[CHINESE]
[ARABIC]

3
INSIDE
CONTENU • CONTENIDO • INHALT • CONTENUTO • CONTEúDO

4
1. READ these instructions.
2. KEEP these instructions.
3. HEED all warnings.
4. FOLLOW all these instructions.
5. DO NOT use this apparatus near water or moisture.
6. If you hear ringing or experience pain or discomfort in
your ears during or after using any in-ear audio product,
that is a sign you are listening too loud.
When your ears are exposed to high volumes (in excess
of 85dB) for over an hour, you may be permanently
damaging your hearing.
7. TURN DOWN your listening device’s volume to zero before
you insert the Klipsch headphones and turn on the device.
Once you have the headphones on, gradually increase the
volume to a comfortable, moderate volume.
8. DO NOT install near any heat sources such as radiators,
heat registers, stoves, or other apparatus (including
amplifiers) that produce heat.
9. ONLY USE attachments/accessories specified by the
manufacturer.
10. REFER all servicing to qualified service personnel.
Servicing is required when the apparatus has been
damaged in any way, such as power-supply cord or plug
is damaged, liquid has been spilled or objects have fallen
into the apparatus, the apparatus has been exposed to
rain or moisture, does not operate normally, or has been
dropped.
IMPORTANT SAFETY INFORMATION

5
11. NEVER operate a motor vehicle while listening to or
wearing your headphones. Not only dangerous,
it is illegal in many places.
12. NEVER operate heavy machinery while listening to or
wearing your headphones.
13. We don’t recommend you use the headphones while riding
a bicycle, running,or walking in heavy traffic areas.
WARNING:
Except in case of emergency, Klipsch recommends you do not use
these headphones or headsets (headphones plus microphone) as
aviation communication equipment as they are not engineered
for many environmental conditions common in commercial or
non-commercial aircraft (including, but not limited to: altitude,
temperature, noise conditions, unpressurized aircraft, etc.)
resulting in possible interference to critical communications.
The Occupational Safety Health Administration (OSHA) has
issued headphone usage recommendations for maximum daily
exposure and sound pressure levels (measured in decibels (dB)).
A decibel is a unit of measure of sound, and decibels increase
exponentially as sound gets louder. For example, conversational
speech is typically around 60dB, and a rock concert in a stadium
is often about 110dB.

6
Sound Pressure Level Recommended Maximum
Exposure Per Day
90dB 8 Hours
92dB 6 Hours
95dB 4 Hours
97dB 3 Hours
100dB 2 Hours
102dB 1.5 Hours
105dB 1 Hours
110dB 30 Minutes
115dB 15 Minutes or less
120dB Avoid as damage may occur
OSHA GUIDELINES FOR NOISE EXPOSURE LIMITS

7
COMPLIANCE INFORMATION
EU COMPLIANCE INFORMATION
Eligible to bear the CE mark; Conforms to European Union Low
Voltage Directive 2006/95/EC; European Union EMC Directive
2014/53/EU; European Union RoHS Directive 2011/65/EU; European
Union WEEE Directive 2002/96/EC; European Union Registration,
Evaluation, Authorization and Restriction of Chemicals (REACH)
Directive 1907/2006.
WEEE NOTICE
Note: This mark applies only to countries within the
European Union (EU) and Norway.
This appliance is labeled in accordance with European Directive
2012/19/EU concerning waste electrical and electronic equipment
(WEEE). This label indicates that this product should not be
disposed of with household waste. It should be deposited at an
appropriate facility to enable recovery and recycling.
FCC EMC COMPLIANCE INFORMATION
NOTE: This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to part 15 of
the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential
installation.
This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that

8
interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference
by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
FCC RADIATION EXPOSURE STATEMENT
This equipment complies with FCC radiation exposure limits set forth for
an uncontrolled environment . This transmitter must not be co-located
or operating in conjunction with any other antenna or transmitter.
Approved under the verification provision of FCC Part 15 as a Class B
Digital Device.
Caution: Changes or modifications not expressly approved by the
manufacturer could void the user’s authority to operate this device.
Caution: To comply with the limits of the Class B digital device,
pursuant to Part 15 of the FCC rules, this device is to comply with Class
B limits. all peripherals must be shielded and grounded. Operation
with non-certified peripherals or non-shielded cables my result in
interference to radio or reception.
COMPLIANCE INFORMATION
This Class B digital apparatus complies with Canadian ICES-003.
This Class B digital apparatus complies with Canadian ICES-003.
ISEDC Radiation Exposure Statement:
This equipment complies with ISEDC RF radiation exposure limits
set forth for an uncontrolled environment.

9
WIRELESS TRANSMITTER COMPLIANCE INFORMATION
This device complies with ISEDC licence-exempt RSS standard (s)
Operation is subject to the following two conditions: (1) this device
may not cause interference, and (2) this device must accept any
interference,including interference that may cause undesired operation
of the device.
PRODUCT REGISTRATION
Register your product online at www.klipsch.com/register
• Klipsch will keep you up-to-date on new products and promotions.
• Your personal information will never be resold.
• This registration information is not used for warranty
purposes. Please retain your receipt for warranty claims.
ls
Le présent areil est conforme aux CNR d'ISEDC licables aux areils
radio exempts de licence.
L'exploitation est autorisée aux deux conditions suivantes:
(1) l'areil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage
radioélectrique subi, même si le brouillage est susceptible d'en
compromettre le fonctionnement.
This transmitter must not be co-located or operating in conjunct
Cet appareil est
conforme aux limitesd'exposition de rayonnement RF ISEDC étab
liespour un environnement non contrôlé.
Cetémetteur ne doit pas être co-implanté oufonctionner en conj
onction avec toute autreantenne ou transmetteur.

10
CONTROLS
HOLD
2 SECONDS
HOLD
2 SECONDS
POWER/PAIR
CHARGING
JACK
STATUS
INDICATOR