Klus MICRO-H User manual

www.KlusDesign.eu 1
WARNING! All LED strips should be connected to a 12 V or 24 V power supply.
IMPORTANT: The mounting instructions present the basic form of assembly.
More methods and related accessories can be found at www.KlusDesign.eu
MICRO-H mounting instructions
Parts needed to mount the MICRO-H extrusion
LED strip (C)
Extrusion (B) Cover (D) End cap (E)Mounting
bracket (A)
Tools needed for mounting:
- screwdriver

A
B
D
C
E
B B
A A
2
www.KlusDesign.eu
MICRO-H mounting instructions
2. Install the LED strip (C) in the extrusion (B), insert the cover (D) and
the end caps (E).
3. Connect power to the LED strip and mount the extrusion (B) in
the mounting brackets (A).
1. Feed the power cable. Attach the mounting bracket (A) to the surface with
screws. It is recommended to use the fasteners at a distance of about 50 cm
from each other, but not less than 2 pieces for one section of the xture.
NOTE! Unusual disassembly of the extrusion. Move the extrusion (B)
horizontally, gently pull one of the sides of the extrusion (B) down, and take
the extrusion o the mounting brackets (A).