KMC Controls TPE-1001 User manual

TPE-1001 1 Installation Guide
Installation Guide
Pressure Transducer (P-E/I)
TPE-1001
Mounting
The TPE-1001 may be mounted either on a surface,
such as a panel backplate, or in a deep 2" x 4" handy
box. A deep box is required to accommodate the
3/16" (5 mm) diameter tubing connection.
Connections and Wiring
1. Connect 1/4" (6 mm) O.D. tubing to the 0–15 psi
port.
2. Connect the terminals of ONE (only) of the
outputs (0–5 VDC, 0–10 VDC, or 0–20 mA) to the
appropriate load (500 ohms max. for 0–20 mA or
1000 ohms min. for 0–5/0–10 VDC). (See also the
Input/Output Calibration section.)
3. Connect the 24 VAC terminals to a 24 VAC (+20%,
–15%), Class 2 transformer. (Multiple units may
be supplied from an individual transformer.)
Mounting 1
Connections and Wiring 1
Input/Output Calibration 2
Maintenance 2
Specifications 2
Important Notices 2
CAUTION
Pneumatic devices must be supplied with clean, dry
control air. Any other medium (e.g., oil or moisture
contamination) will cause the device to fail.

TPE-1001 2 Installation Guide
© 2012 KMC Controls, Inc. 858-019-01E
KMC Controls, Inc.
19476 Industrial Drive
New Paris, IN 46553
574.831.5250
www.kmccontrols.com
[email protected]
Maintenance
No routine maintenance is required. Each compo-
nent is designed for dependable, long term reliability
and performance. Careful installation will also
ensure long term reliability and performance.
Important Notices
The material in this document is for information
purposes only. The contents and the product it
describes are subject to change without notice.
KMC Controls, Inc. makes no representations or
warranties with respect to this document. In no event
shall KMC Controls, Inc. be liable for any damages,
direct or incidental, arising out of or related to the
use of this document.
Specifications
Supply Voltage 24 VAC (+20%, –15%), Class 2
Supply Power 0.5 VA
Input Signal 0–15 psi (0–103 kPa), 30 psi
max. (207 kPa), using 1/4" (6
mm) O.D. polyethylene tubing
Output Signal 0–5 VDC, 0–10 VDC, 0–20 mA
Output Accuracy +/– 3%
Material Beige ame-retardant plastic
Wire Size 14 to 22 AWG recommended
Receiver Load 500 ohms max. for 0–20 mA
1000 ohms min. for 0–5/0–10
VDC
Weight 2 oz. (57 grams)
Temperature Limits
Operating 40 to 120° F (4 to 49° C)
Shipping –40 to 140° F (–40 to 60° C)
Input/Output Calibration
The input and output ranges are designed so that
a normal 3–15 psi pneumatic signal will generate
output signals of 1–5 VDC, 2–10 VDC, or 4–20 mA.
These ranges are detailed in the graph below.
NOTE: A 3–15 psi signal generates 1–5 VDC, 2–10
VDC, or 4–20 mA.