Quickstart Guide -qVDP103 Copyright 2021 System Q Ltd
2This symbol indicates that equipment must not be mixed with general household waste. For treatment, recovery and recycling please return to your local designated
WEE/CG0783SS collection point as defined by your local council.
DoorKnox Keypad Video Door Entry Camera
Doorknox is a registered trademark of System Q Ltd
All specifications are approximate. System Q Ltd reserves the right to change product specifications or features without notice. Whilst every effort is
made to ensure that these instructionsare complete andaccurate, System Q Ltd cannot be held responsible for any losses,no matter how they arise,
from errors or omissionsin these instructions, or the performance or non-performance of the equipment refered to.
When mounting the door entry camera it is
recommended to be installed between 150 to 160cm
above the floor (About 5 feet) it should not be mounted
in direct sunlight.
When recess mounting the camera create a recess of
200mm (h) x 96mm (w) x 29mm (d).
It is important that the recess created is no more than
30mm deep otherwise the securing screws cannot be
accessed.
Default Settings
Admin PIN - 999999
Entry Pin - No Default
Unlock Mode - Card or PIN
Unlock Time - 2s
Safe Mode -Off
Entering Admin Mode
Press *(Admin PIN )# the VDP103 will beep 2 twice and
the light behind the name panel will flash slowly.
If an incorrect PIN is entered the VDP103 will beep 4
times.
For security reasons it is best to change the Admin PIN
during installation.
Adding an Entry PIN
Adding an Entry Pin will allow access regardless of the
unlock mode that the VDP is set to.
In admin mode:-
Press 011#nnnnnn# (single beep)
nnnnnn# (double beep)
Note: nnnnn n = new 6 digit PIN.
To release an electronic
door using a PIN, simply
enter the PIN followed by
the ‘#’ key. You will hear
two short beeps if the PIN
is correct, otherwise you
will hear four short beeps.
For programming fobs
or cards see the full
manual
