Kodak PIXPRO AZ652 User manual

KODAK PIXPRO AZ652
DIGITAL CAMERA
User Manual

1
Declaration of Conformity
Responsible Party: JK Imaging Ltd.
Address: JK Imaging Ltd., 17239 So. Main Street, Gardena, CA 90248 USA
Company Website: kodakpixpro.com
INDUSTRY CANADA
This device complies with Canadian RSS247.
This device complies with Industry Canada license-exempt RSS standard (s). Operation
is subject to the following two conditions: (1) this device may not cause interference
and (2) this device must accept any interference, including interference that may cause
undesired operation of the device.
Radiation Exposure Statement:
This product complies with the Canadian portable RF exposure limit set forth for an
uncontrolled environment and is safe for intended operation as described in this manual.
Additional RF exposure reduction can be achieved if the product can be kept as far as
possible from the user body or set the device to lower output power if such function is
available.
BEFORE YOU START

2
For Customers in Europe
This symbol [crossed-out wheel bin WEEE Annex IV] indicates separate collection
of electrical waste and electronic equipment in the European countries. Please do
not throw the equipment into domestic refuse. Please use the return and collection
systems available in your country for proper, safe disposal of this product.
“CE” mark indicates that this product complies with the European requirements
for safety, health, environment and customer protection. “CE” marked cameras are
intended for sales in Europe.
Europe – EU Declaration of Conformity
This device complies with the essential requirements of the R&TTE Directive
2014/53/EU. The following test methods have been applied in order to prove
presumption of conformity with the essential requirements of the R&TTE Directive
2014/53/EU:
- EN 623681:2014
Safety of Information Technology Equipment
- EN 50566:2017
Product standard to demonstrate compliance of radio frequency ields from
handheld and body- mounted wireless communication devices used by the general
public (30 MHz — 6 GHz)
- EN 622092:2010/A1:2019
Human exposure to radio frequency ields from handheld and bodymounted
wireless communication devices — Human models, instrumentation, and
procedures
Part 2: Procedure to determine the speciic absorption rate (SAR) for wireless
communication devices used in close proximity to the human body (frequency
range of 30 MHz to 6 GHz)

3
- EN 300 328 V2.2.2 (201907)
Electromagnetic compatibility and Radio spectrum Matters (ERM); Wideband
transmission systems; Data transmission equipment operating in the 2.4GHz ISM
band andusing wide band modulation techniques; Harmonized EN covering the
essential requirements of article
- EN 301 4891 V2.2.3 (201911)
Electromagnetic compatibility and Radio Spectrum Matters (ERM); Electro
Magnetic Compatibility (EMC) standard for radio equipment and services; Part 1:
Common technical requirements.
- EN 301 489 -17 V3.2.4 (202009)
Electromagnetic compatibility and Radio spectrum Matters (ERM); ElectroMagnetic
Compatibility (EMC) standard for radio equipment; Part 17: Speciic conditions for
Broadband Data Transmission Systems
Hereby, Sintai Optical (Shenzhen) Co., Ltd, declares that this PIXPRO AZ652 is
in compliance with the essential requirements and other relevant provisions of
Directive 2014/53/EU.
Manufacturer: Sintai Optical (Shenzhen) Co., Ltd
Address: Qiwei Ind Sec, 1st, 2nd,& 3RD Bldg, Lisonglang Village, Gongming Town,
Bao’an District, Shenzhen, Guangdong, China
Batteries: Please dispose of used batteries at designated collection centers.
Packaging: Please follow local regulations for the recycling of packaging.
For Customers in the U.S.A.
Federal Communication Commission Interference Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.

4
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: Any changes or modiications not expressly approved by the party
responsible for compliance could void the user’s authority to operate this equipment.
This transmitter must not be co-located or operating in conjunction with any other
antenna or transmitter.
Radiation Exposure Statement:
This product complies with the FCC portable RF exposure limit set forth for an
uncontrolled environment and is safe for intended operation as described in this manual.
Additional RF exposure reduction can be achieved if the product can be kept as far as
possible from the user body or set the device to lower output power if such function is
available.

5
About this Manual
Thank you for purchasing this KODAK PIXPRO Digital Camera. Please read this manual
carefully and keep it in a safe place for future reference.
JK Imaging Ltd. reserves all rights of this document. No part of this published manual
may be reproduced, transmitted, transcribed, stored in a retrieval system or translated
into any language or computer language, in any form, by any means, without the prior
written permission of JK Imaging Ltd.
All trademarks mentioned in this manual are used for identiication purposes only and
are properties of their respective owners and holders.
This manual provides you with instructions on how to use your new KODAK PIXPRO
Digital Camera. Every effort has been made to ensure that the contents of this manual
are accurate; however JK Imaging reserves the right to make changes without notice.
Throughout this manual, the following symbols are used to help you locate
information quickly and easily:
Indicates useful information.
The following symbols may be used throughout this manual to facilitate your
understanding of how to operate the camera:
[Item properties] : The optional properties in the camera interface are indicated by the
[ ] symbol.

6
SAFETY NOTES
Safety Notes for this Camera
Do not drop the camera or allow it to
hit solid objects.
Do not attempt to disassemble or
repair the camera.
Do not use or store the camera in dusty
places or on a beach to help prevent
dust or sand from entering the camera,
causing possible damage.
Do not use or store the camera in a hot
environment or in direct sunlight.
Do not use or store the camera near
powerful magnetic ields, such as a
magnet or transformer.
Avoid touching the lens of the camera.
Do not expose the camera to direct
sunlight for a long period of time.
To prevent the camera from being
damaged by moisture, do not use
or store the camera in very humid
environments, such as in rain or near
bodies of water.
If water accidentally comes in contact
with the camera, turn the camera off
immediately, remove the battery and
the memory card and dry it completely
within 24 hours.
When you take the camera from a cold
environment to a warmer environment,
condensation may occur. Please wait
for a reasonable period of time before
you turn the camera on.
Before you remove the battery and
memory card, the camera should be
turned off.
When you clean the body of the
camera, do not use abrasive, alcohol-
based or organic cleansers or solvents.
Use a professional lens cleaning cloth
and appropriate cleaner to wipe and
clean the lens.
Download your photos and remove the
memory card when you are going to
store the camera for long periods of
time.
If this camera is not in use for a long
period of time, please keep it in a dry
and clean storage location.
Our company will not pay
compensation for any failure of
playback including: pictures or
videos damaged or unrecoverable by
improper operation.

7
Safety Notes for Battery
Please use a battery that is the same
type as the one included.
Please use the attached charger to
charge the battery.
If battery luid leaks inside the
camera, contact our customer service
department immediately. If battery
luid leaks onto your skin, rinse your
skin immediately with clean water and
seek immediate medical attention.
Disposal of used batteries should be
carried out in accordance with your
local (national or regional) regulations.
To prevent the battery from being
damaged, do not drop the battery or
allow it to hit solid objects or to be
scratched by foreign objects.
Do not let the battery come in contact
with metal objects (including coins)
to avoid short circuiting, discharging,
excessive heat or possible leakage.
Do not attempt to disassemble the
battery.
Do not expose the battery to water.
Always keep the battery contacts dry.
Do not heat the battery or throw it into
a ire to avoid a possible explosion.
Do not store the battery in a hot
environment or in direct sunlight.
If the battery overheats during
charging or use, stop charging or use
immediately. Turn off the product,
remove the battery carefully, and wait
until it cools down.
When the camera is stored for a long
period of time, remove the battery and
keep it in a safe, dry place that is not
accessible to infants and children.
In colder environments, the
performance of the battery could be
noticeably reduced.
When you install the battery, align the
battery markings according to the
positive and negative markings inside
the camera battery compartment.
Never force the battery into the battery
compartment.

8
Safety Notes for Memory Card
We highly suggest buying only well-
known, name brand memory cards
to ensure peak performance and
reliability.
Format the memory card using the
camera before you use it or insert a
new one.
Do not drop the memory card or
allow it to hit solid objects to avoid
damaging it.
Do not attempt to disassemble or
repair the memory card.
Do not expose the memory card to
water. Always keep it dry.
Do not remove the memory card when
the camera is turned on. Otherwise,
the memory card and photo/video iles
could be permanently damaged.
Do not directly edit the data on the
memory card. Copy the data to your
computer before you edit iles.
When the camera is stored for long
periods of time, be sure to download
your photos and remove the memory
card. Store the memory card in a dry
environment.
Do not modify the name of the iles
or folders of the memory card using
your computer. Modifying the ile
names may cause the iles to not
be recognized on the camera or a
possible permanent error may occur.
A photo taken with the camera
will be stored in the folder that is
automatically generated on the
memory card. Do not store photos
that are not taken using this camera in
these folders as the pictures cannot be
recognized during playback.
When you insert the memory card,
make sure the notch of the card
matches the markings on the top of
the camera card slot.

9
Other Safety Notes
Do not disconnect the power or turn the camera off during the update process. Doing
so may cause incorrect data to be written and the camera may not power on later.
Do not hang the neck strap of the camera around the neck of a child.
When using your camera on an airplane, observe the relevant rules speciied by the
airline and FAA regulations.
Due to the limitations of manufacturing technology, the LCD may have a few dead
or bright pixels. These pixels do no effect the quality or performance of the camera,
photos or video.
Do not expose the camera’s LCD to water. In a humid environment, only wipe it with a
soft, dry, cleaning cloth.
If the LCD is damaged and the liquid crystal comes into contact with your skin, wipe
your skin with a dry cloth immediately and rinse it with clean water. If liquid crystal
comes into contact with your eyes, wash them with clean water at least for 15 minutes
and seek immediate medical attention. If you accidentally swallow liquid crystal, rinse
your mouth immediately and seek medical attention.
Trademark Information
The terms HDMI, HDMI High-Deinition Multimedia Interface, HDMI Trade dress
and the HDMI Logos are trademarks or registered trademarks of HDMI Licensing
Administrator, Inc.
WARNING
Altering, tampering or modifying the any parts of AZ652 camera are unauthorized
and will void the manufacturer’s warranty and “could” void Federal and/or State
Compliance.