Kogan CERTA C319 User manual

C319 CORDLESS AIR
COMPRESSOR
CTAICOC319A

•Make sure the battery is fully charged before use.
•After use, lock the safety buckle to prevent misuse.
•Do not attempt to modify or disassemble this product.
•Do not use this product around flammable liquids or gases.
•Do not place this product near the heat source.
•It is normal for the air compressor to get hot, especially if you are running the
compressor for an extended period or using during hot weather. Take note of the
heat, allowing for the compressor to cool down during continuous use. Do not
touch if overheating.
❶Digital display
❹Safety buckle
❼Inflation switch
❷Inflation inlet
❺Hand grip
❽Inflation tube
❸LED lamp
❻Charging input
❾USB power cord
SAFETY & WARNINGS
OVERVIEW

1. Connect the inflation tube to the inflation inlet (Fig .1)
Fig.1
2. Secure the inflation tube to the inflation inlet by tightening the collar (Fig.2)
Fig.2
3. Ensure the tool is stable and confirm the pressure required before powering it on.
4. Open the safety buckle.
5. Tu rn on the inflation switch to confirm the nozzle connection without air leakage.
Press “R” to switch between measurement units.
Pre-set the tire pressure by pressing “+” or “-“ to add or subtract numerical values,
then turn on the air inflation switch for operation once the value stops flickering.
The air pump will stop automatically once inflated to the set pressure. Turn off the
switch and unscrew the inflation tube once completed.
Fig.3
OPERATION
Unit switch button
Unit display
“+” key
Current air pressure
“-” key

Power
120W
Input voltage
12.6V
Discharge time
30 minutes
Battery capacity
2200mA
Problems
Causes and solutions
Unit will not power on
May be caused by low battery; recharge the unit as soon as
possible
Failure to pre-set tire pressure or wait for the display to stop
flickering the desired pressure has been set. Set the tire
pressure again and inflate after the display stops flickering.
Charge lamp is off
Confirm the power cord is securely connected with the
product and the air pump is closed.
The product operates
abnormally
The inflation tube and tire are not properly connected.
Failure to pre-set tire pressure or wait for the display to stop
flickering the desired pressure has been set. Set the tire
pressure again and inflate after the display stops flickering
(the pressure needed for the tire will be indicated on the tire
itself, otherwise, refer to the tire manufacturer).
SPECIFICATIONS
TROUBLESHOOTING

NOTES

Need more information?
We hope that this user guide has given you
the assistance needed for a simple set-up.
For the most up-to-date guide for your product,
as well as any additional assistance you may require,
head online to help.kogan.com