Kogan KACONMICPHA User manual

USB CONDENSER
MICROPHONE
WITH POP FILTER & STAND
KACONMICPHA

 Lower the volume before moving the microphone as very loud feedback can occur
when the top of the microphone is covered by hands or the microphone is moved
near to the speaker.
 Take care not to let the microphone fall or suffer physical damage.
 Do not store the microphone in a hot or damp place.
1. Connect the base to the stand.
2. Hand-loosen the base using the dial on the back to adjust its clearance, then slide
it over the installation surface and tighten it to secure. Use the small screw on the
bottom to tighten further.
3. Connect the top of the bracket to the plastic shock-proof frame.
4. Use the large screw button of the bracket to adjust the bracket angle and use the
small screw button on the frame to adjust the frame angle.
SAFETY & WARNINGS
INSTALLATION

5. Install the pop filter and sponge ball as shown below. Connect the audio cable
and route it through the shock-proof stand.
6. After the microphone is installed and connected, plug the audio cable to the sound
card and connect the sound card to the computer – alternatively, the audio cable
can be connected directly to the computer.
Polar pattern Unidirectional
Frequency response 20Hz-20kHz
Sensitivity -34dB±2dB (0dB=1V/Pa at 1kHz)
Output impedance 150Ω±30% (at 1kHz)
Load impedance ≥1000Ω
Equivalent noise level 16dBA
Maximum SPL 130dB (at 1kHz ≤ 1% T.H.D)
S/N Ratio 78dB
Electrical current 3mA
SPECIFICATIONS

A. Shock-proof stand B. Condenser microphone
C. USB sound card D. Microphone holder
E. Audio line F. Sponge ball
G. Pop filter H. Base
I. Vibration control frame
IN THE BOX

Need more information?
This is a Quick Start Guide, and we hope that this
has given you the assistance needed for a simple set-up.
For the most up-to-date guide for your product,
as well as any additional assistance you may require,
head online to help.kogan.com