Kohler 45429IN User manual

45429IN
(174)
(90)
G1/2”
(11)
(Φ102)
(Φ64)
16356IN-A
(179)
(95)
G1/2”
(11)
(Φ97)
(Φ64)
45431IN
(174)
(131)
G1/2”
(22.9)
(Φ84)
(Φ74)
45429IN 45431IN
BEFORE YOU BEGIN
ROUGH-IN DIMENSIONS
SHOWERHEAD WITH ARM & ESCUTCHEON
All information is based on the latest product information available at the time of publication.
kohler Co. reserves the right to make changes in product characteristics, packaging, or
availability at any time without notice.
Please leave these instructions for the consumer. They contain important information.
NOTE:
1. Observe all local plumbing and building codes.
2. Flush the water supply pipes thoroughly to remove any debris.
3. Highest working pressure for handspray & shower head is 0.5MPa (5 bar). If it exceeds
0.5MPa(5 bar), a pressure reducer is needed. The highest and environment temperature is
600C. Please keep handspray, shower head and shower arm away from heater, or it may
get damaged and cause injury to the user.
16356IN-A
1176596IN Rev-B 1
Kohler India Corporation Pvt. Ltd.
6th Floor, Office Block
Ambiance Mall, Ambi Island, NH-8
Gurgaon-122002
Haryana, India
Customer Care No : 1800 103 2244 (Toll Free) & [phone] / 86
Customer Care Email : [e-mail]
www.kohler.co.in
INSTALLATION INSTRUCTIONS

1209792-**
Showerhead
(only for 45429IN)
1182075-**
Showerhead
(only for 16356IN-A)
1061577-**
Shower Arm
(only for 45429IN/ 16356IN-A)
1178080-**
Escutcheon
(only for 45429IN/ 16356IN-A)
1209928-**
Showerhead
(only for 45431IN)
1174543-**
Escutcheon
(only for 45431IN)
1174539-**
Shower Arm
(only for 45431IN)
1
3
2
176596IN Rev-B176596IN Rev-B
Remove the temporary nipple. Slide the escutcheon over the shower arm(2). Apply tape or
sealant to the shower arm, and install the shower arm into the shower elbow(1). Tight with a
strap wrench. Push the escutcheon against the wall.
Flush both water supplies through the shower arm for one minute before the shower head is
installed. Apply tape or sealant to the exposed end of the shower arm. Tighten the
showerhead(3) with a strap wrench.
SHOWERHEAD WITH ARM & ESCUTCHEON
16356IN-A
45429IN 45431IN
All Finishes: Clean the finish with a mild soap and warm water. wipe entire surface completely with a clean soft
cloth. Many cleaners may contain chemicals, such as ammonia, chlorine, toilet cleaner etc.,
Do not use abrasive cleaners or solvents on Kohler faucets and fittings.
To dislodge debris and mineral build-up:
Run water through the showerhead.
Firmly rub your finger back and forth
across the spray holes in the
showerhead face
CLEANING INSTRUCTIONS
SERVICE PARTS
INSTALLATION
2 3
**Color code must be specified when ordering