komodo Colossus User manual

Colossus 10 Person Tent
KDTNT10CLSA
Quick Start Guide
Safety Warnings
This tent has been developed and is intended to provide shelter from sun and light rain. It is not intended for use during
heavy rain, wind, hail or snow.
•The tent should be dismantled when not in use.
•Do not use any gas or flame sources under, inside or near this product.
•Under no circumstances should this product be used as a permanent or temporary storage facility.
This product meets the flammability requirements of CP I-84. This product is not fire proof. The fabric may burn if left in
continuous contact with any flame source.
Never use devices that produce fumes, including stoves, lanterns, candles or heaters in or around this tent.
Asse bly
Step 1: Check products are all present-
Inner tent, outer tent, poles, tent pegs
and the guy ropes.
Step 2: Unroll the inner tent. Lay the
fibreglass poles out in order alongside
the sleeves on the outside of the tent.
Step 3: Slide the fibreglass poles into
the insert sleeves.
Step 4: Once threaded through the
sleeves, put the ends of the fibreglass
poles through into the plastic tubes.
Step 5: Raise the tent by bending the
fibreglass poles and placing their ends
over the corresponding pole pins.
Step 6: Once the poles are all raised,
attach the tent clips to the fibreglass
poles.
Step 7: Check that the fibreglass poles
are firmly inserted into the plastic
tubes and that they are standing
steadily.
Step 8: Check that the ends of the
steel poles are fitted securely over the
streel ring pins at each corner of the
tent.
Step 9: The steel poles will support the
opening flap section of the tent.

Step 10: Use the wire tent pegs to peg
the base of each pole to the ground.
Drive the pegs into the ground at a
45° angle.
Step 11: The assembled inner tent
should appear as shown above.
Step 12: Insert the outer tent fibreglass
poles through the hooks on the tent
itself.
Step 13: Tie the fibreglass poles to the
outer tent using the straps in the
center.
Step 14: Turn the outer tent the right
way up (with fibreglass poles on the
inside), and lay it over the inner tent.
Step 15: Peg the outer tent to the
ground. Start with the rear corners,
then the front corners, then finally the
sides.
Step 16: Use the S hooks to secure the
fibreglass poles to the tent walls.
Step 17: Secure all fibreglass poles
using the available S hooks.
Step 18: The tent is now ready for use.
Disasse bly
To disassemble the tent, simply reverse the steps.
If the tent has rainwater or morning dew on it, allow the cover to fully dry before packing up. If you are unable to allow
the tent to dry out while packing it up, unpack it and allow it to dry at the soonest possible time to avoid the growth of
mold or mildew.
If you have any further enquiries or concerns regarding the setup or usage of this tent, please
contact the Kogan custo er support tea .