Konig SEC-APD10 User manual

SEC-APD10
MOTION ALARM
With Telephone Dialer
Description:
1. PIR sensor
2. Siren
3. Microphone
4. Battery LED indicator
5. Keypad
6. Telephone connection
7. Battery Compartment
Battery installation:
1. The battery compartment is accessed from
the rear of the alarm by removing the screw
from the bottom and lifting the back cover
(see figure B).
2. Insert 4x AAAsize
batteries (not included)
according the polarity as
shown in figure C.
3. When the last battery is inserted the alarm will
beep very loud to indicate that the batteries are
installed properly. Replace the back cover.
ENGLISH
INSTRUCTIONS

Wall Mounting:
1. Remove the back plate.
2. Mount the back plate to the desired position wall.
3. Clip the unit to the back plate.
4. Secure the PIR sensor to the back plate by fastening the screw
on the bottom.
Telephone connection:
Remove the back plate of the alarm (see figure B) and connect the
telephone cable to the alarm (6) and telephone wall socket.
Programming the alarm:
Immediately,after inserting the batteries, the 4-digit security code
must be set, simply press a desired 4 digits code onto the keypad.
Do not use ”0” as the first digit for the security code, “0” is the digit
to arm the alarm.
Note: the alarm must be programmed again with the security code
each time the batteries are removed or replaced. It’s not necessary
to store new telephone numbers or record a new voice message.
Program telephone numbers:
1. Press
and insert the 1st telephone number.
2. Press to confirm.
3. Press for inserting 2nd telephone number.
4. Etc.
Maximum 3 telephone numberswith max 16 digits can be stored.
Note: only use friends and families telephone numbers. Do not use
emergency service numbers.
(can be used with a PABX phone system)

Record a message:
Press , the battery LED indicator light will illuminate.
You have 6 seconds to record your personal message. Once the
light goes off your recording time is over.
The alarm has a permanent memory for stored telephone numbers
and voice message. To change the telephone number or recorded
message, repeat above.
Silent alarm:
It’s possible to use the alarm as a silent alarm. In this case the siren
will not loud but only the telephone dialer will work.
Press to activate the silent alarm. To retrieve the siren
press .
Operation:
Press, when leaving, keypad number . A confirmation tone will
sound to indicate the alarm is armed. You have 30 seconds to leave
the area. After this time, if motion is detected the alarm will start to
dial the stored telephone numbers after 10 seconds (delay time)
and the alarm siren will sound 20 seconds after the first telephone
number is dialed.
Press, when entering, the 4-digit security code within 10 seconds,
to disarm the alarm.
When the alarm is activated, it will dial the first stored telephone
number. If the first telephone number is not answered within 45
seconds the second stored number will be dialed and so on. All
three stored telephone numbers will be dialed if the unit is activated,
unless the security code is entered to disarm the alarm.
Remark: if the LED indicator is constantly on, it means that the
batteries need to be replaced.

Warning:
To reduce risk of electric shock, this product should ONLY be
opened by an authorized technician if service is required. Do not
expose the product to water of moisture.
Warranty:
No guarantee or liability can be accepted for any changes and
modifications of the product or damage caused due to incorrect use
of this product.
General:
Designs and specifications are subject to change without notice.
www.konigsecurity.info