KonNad C2000-A2-SDD6060-CAX User manual

Last updated: 2019-12-13
C2000-A2-SDD6060-CAX
User Manual
6DO ← 6AC
AC 90-275V
Remote I/O Module — AC Digital Input Module
SinoCon Co., Ltd.

2
5
5
6
7
8
9
9
10
11
Catalog
Catalog
1. Hardware Description
1.1. Specifications
1.2. Apprearance
1.3. Indicators
1.4. Port Description
1.5. Product Dimensions
1.6. Installation Method
2. Package Contents
3. Warranty Policy
C2000-A2-SDD6060-CAX User Manual
2 / 11
SinoCon Co., Ltd. www.sinoconsys.com

Copyright Notice
©2000 - 2019 SinoCon Co., Ltd. All Rights Reserved.
Trademarks
The KonNaD logo is a registered trademark of SinoCon Co., Ltd. All other trademarks or registered marks in this
manual belong to their respective manufacturers.
Disclaimer
This document only provides information about KonNaD products. No license to any intellectual property rights is
granted by this document, including any intellectual property licenses, expressed or implied, or by any means.
SinoCon assumes no responsibility other than the liability stated by SinoCon in the terms and conditions of sale of
its products and SinoCon makes no warranties regarding the sale or use of KonNaD products, including the
suitability for the specific use of the products, and marketability, and SinoCon doesn't guarantee that it won't
infringe any patent, copyright or other intellectual property rights, etc.
Information in this document is subject to change without notice and does not represent a commitment on the
part of SinoCon.
Contact US
SinoCon Co., Ltd.
Address: 16th Floor, Tower A, Zhongyin Building, Caitian Road, Futian District, Shenzhen, China
Web: www.sinoconsys.com
Tel: [phone]
C2000-A2-SDD6060-CAX User Manual
3 / 11
SinoCon Co., Ltd. www.sinoconsys.com

C2000-A2-SDD6060-CAX User Manual
4 / 11
SinoCon Co., Ltd. www.sinoconsys.com

1. Hardware Description
1.1. Specifications
Classification Parameter Specification
AC Input AC Channels 6
Connector Terminal block
AC Type Wet contact
Channel-to-Channel Isolation 1500Vrms
Acquisition Frequency 1kHz
Logic Logic 0: ≤ 75VAC, Logic 1: 90~275VAC
Digital Output DO Channels 6
DO Connector Terminal block
DO Type Open-collector Output
DO Mode Logic Level
Physical Characteristics Dimensions 75*105*30mm
Installation Din-rail or wall
Environmental Limits Operating Temperature -40℃ ~ 85℃
Storage Temperature -60℃ ~ 125℃
Ambient Relative Humidity 5% ~ 95% RH, non-condensing
C2000-A2-SDD6060-CAX User Manual
5 / 11
SinoCon Co., Ltd. www.sinoconsys.com

1.2. Apprearance
C2000-A2-SDD6060-CAX User Manual
6 / 11
SinoCon Co., Ltd. www.sinoconsys.com

1.3. Indicators
Classification Indicator Description Meaning
AC Input Lx AC input
indicators
Steady on：Input voltage more than the threshold voltage
(90VAC)
Off：Input voltage less than the threshold voltage
(90VAC)
C2000-A2-SDD6060-CAX User Manual
7 / 11
SinoCon Co., Ltd. www.sinoconsys.com

1.4. Port Description
Classification Port Description Recommended wiring
AC Input L、N AC live wire, AC neutral wire -
Digital Output NO Digital output normally open RVV 2*1.0
COM Digital output common RVV 2*1.0
C2000-A2-SDD6060-CAX User Manual
8 / 11
SinoCon Co., Ltd. www.sinoconsys.com

1.5. Product Dimensions
unit: mm（inch）
1.6. Installation Method
C2000-A2-SDD6060-CAX User Manual
9 / 11
SinoCon Co., Ltd. www.sinoconsys.com

2. Package Contents
No. Contents
1 Device (contain mounting kit) * 1
2 Terminal block * 1 set
3 Installation guide card * 1
C2000-A2-SDD6060-CAX User Manual
10 / 11
SinoCon Co., Ltd. www.sinoconsys.com

3. Warranty Policy
In the normal use of the products you purchased, free warranty service will be provided from the date of
purchase whenever the quality problems caused by raw materials or production process are concerned. However,
due to the user's failure to install, disassemble or improperly use the product according to the requirements of this
product manual, the company provides maintenance services, but charges appropriate maintenance fees. The
warranty period is as follows:
Product category Warranty Period
Shelled product 6years
Unshelled product 3years
Note: Accessories are not covered by warranty.
Warranty Terms:
1. From the date of purchase, in the case of normal use (determined by the company's authorized
technicians), the failed product will be repaired free of charge during the warranty period.
2. Products that have been repaired or modified by a maintenance personnel other than our company
during the warranty period, or that have been improperly installed, incorrectly input voltage, improperly
used, accidental events or natural disasters, etc., are not covered by the warranty.
3. Before accepting the warranty service, the customer is required to prove the date of purchase of the
product by presenting the warranty card or purchasing the invoice. Otherwise, the warranty cannot be
guaranteed.
4. For all warranty or repair products, the customer bears the risk of shipping and shipping costs.
5. If the product exceeds the warranty period or does not meet the warranty requirements, the company will
provide charge maintenance.
6. The warranty terms for customized and ODM products should be defined in the contract.
7. Other verbal commitments that conflict with this warranty would be executed with reference to this
warranty.
8. Our company's responsibility for the manufacture, sale and use of the products shall not exceed the
original cost of the products. The company does not assume any joint responsibility.
9. The right to interpret this clause belongs to the company.
C2000-A2-SDD6060-CAX User Manual
11 / 11
SinoCon Co., Ltd. www.sinoconsys.com