Kramer SHOWMASTER WL60 User manual

WET / DRY VACUUM CLEANER
FOR HORSE GROOMING
Owner’s Guide
www.kramer.co.uk

2|PARTS
1 | Wet / dry vacuum cleaner
2 | Safety feature that ensures proper motor function
3 | Caddy frame provides space for accessories
1|PRODUCT FEATURES
Plug
Electrical cord
Swivelling castor
Locking tab
Caddy frame
Hose connection
port
Canister
Switch
Top cover
Handle
Filter
Model Power Voltage Frequency
WL60 1200/1400 W 220 V-240 V 50 Hz
Canister cover

3|SAFETY INSTRUCTIONS
1 | Suitable for any 220 V socket. UK Plug adapter
included.
2 | Do not operate in dangerous areas. The motor
could emit sparks and cause a fire.
3 | Do not block the hose connection vent as this
may cause overheating and lead to product da-
mage.
4 | Do not suck up flammable or explosive objects
such as lighted cigarettes, petrol, etc.
* | Avoid sharp objects. * | Keep filter clean! Do not suck up materials such
as plaster, chalky powder or graphite dust. The-
se can block the filter.

3|SAFETY INSTRUCTIONS
5 | To avoid water damage to the motor, do not let
the appliance tip over.
6 | Attention: should water leak from the blower
port, do not tip or turn over the appliance to re-
pair it. Water could enter the motor and cause
damage. Do not use this appliance as a pump.
7 | Switch the appliance off and disconnect it from
the power mains after use or to carry out re-
pairs.
8 | To avoid damage to plastic parts, do not leave
the appliance in the direct sunlight or anywhere
where high temperatures are prevalent.
9 | Do not put fingers or objects in the hose or pull
on the hose.
10 | Do not submerge the canister cover in water
or wash it, as injury may be caused to peop-
le if water comes into contact with electrical
parts. To clean, simply wipe with a moistened
cloth.

1 | Connect the plug to the mains.
2 | Press switch to turn on.
4|FIRST USE
„I“ on
„O“ off
Connection
Push the end of the hose into
the hose connection port on the
side of the canister.
Always assemble the pieces as shown on the picture.
Hose end
Hose connec-
tion port

1 | When the canister is full with water, the safety feature will be activated. Which means that the suction force
decreases and the appliance produces a sound to indicate that it is full. If this happens, disconnect the po-
wer and empty the canister. Then switch the appliance back on.
2 | Should the appliance tip over, the safety feature starts up automatically. Please switch off the power and set
the device upright again. Turn it back on.
3 | If this safety feature is still in operation and the appliance is still in use, the appliance could overheat thus
resulting in damage such as fire. In this case turn off the appliance and empty the canister. The appliance
is once again ready for use.
5|SAFETY FEATURES
6|MAINTENANCE
1 | Cleaning the canister
* After using this appliance or when the canister is full, disconnect from the mains and empty the canister.
1 | Open the locking clips and remover the canister cover.
2 | Remove the filter bag and empty the dust .
3 | Replace the filter bag and reattach the canister cover.
2 | Cleaning the filter bag
When the filter bag is dirty, it should be washed in clean, warm water, If necessary, a light detergent may be used.
1 | Remover filter
2 | Wash
3 | Let air dry thoroughly