KUSSMAUL 091-35-HO User manual

INSTRUCTION MANUAL
BATTERY SAVER HO
POWER SUPPLY / AUTOMATIC LOAD SWITCH
MODEL #091-35-HO
TEL: in NY 631-567-0314 TOLL FREE: 800-346-0857 FAX: [phone]
3 YEAR WARRANTY
NOTE :
This Battery Saver is designed
for negative ground vehicles.
INPUT :120 Volts, 50/60 Hz, 4amperes
BOOK# 091-35-HO-1
OUTPUT: 12VDC, 20 AMPERES D.C.
KUSSMAUL ELECTRONICS CO., INC.
170 CHERRY AVE., WEST SAYVILLE, N.Y. 11796

INTRODUCTION
The BATTERY SAVER HO is a power supply with transfer relay. Loads connected to the
BATTERY SAVER HO are energized from the vehicle’s battery when the A.C. battery is OFF. As
soonasA.C.powerisapplied,thepowersupplyprovides12voltsD.C.andtherelaytransfersthe
loadstothepowersupply.Thusthereisnodrainonthebatteryandtheentireoutputofthevehicle’s
battery charger is available to charge the battery.
INSTALLATION
1. Mount the BATTERY SAVER HO in a convenient location with 4 screws in the mounting holes
provided. Becertain that adequateventilation is availableand that theunit is not subjectto water
damage.
2.Connectthe120voltA.C.inputpowertothe BATTERY SAVER HO throughthe3wireline cord
provided.
3. The low voltage connections are made to the terminal strip use 14 gauge wire, see wiring
diagrams .
4.Theinstallationisnowcomplete. Ifdonecorrectly,theloadsshouldbepoweredfromthebattery
when the A.C. power OFF and from the power supply when A.C. power is ON.
TEST
TotesttheinstallationfirstremoveA.C.powerfromthevehicle. Nowdeterminethatpowerisbeing
supplied to the loads. This power should be coming through the BATTERY SAVER HO.
Disconnect the wires to BAT 1,2 on the terminal strip and note that the loads are deenergized.
Leave the wire disconnected and apply 120 volts A.C. power to the vehicle. This should energize
the power supply and the loads. If the loads are energized, then the power supply is functioning
correctly.THETESTISNOWCOMPLETE.NowreconnectthewirestoBAT1,2ontheterminal
strip . This is important!

OUTLINE DRAWING

INSTALLATION RECORD & WARRANTY
Date Installed
Installed By
Vehicle Identification
Vehicle Owner
WARRANTY
All product of Kussmaul Electronics Company Inc. are warranted to
be free of defects of material or workmanship. Liability is limited to repair-
ing or replacing at our factory, without charge, any material or defects
which become apparent in normal use within 3 years from the date the
equipment was shipped.
Kussmaul Electronics Company, Inc. shall have no liability for dam-
ages of any kind to associated equipment arising from the installation and
/or use of the Kussmaul Electronics Company, Inc. products. The pur-
chaser, by the acceptance of the equipment, assumes all liability for any
damages which may result from its installation, use or misuse, by the
purchaser, his or its employees others.