Kustom KG210FX User manual

Congratulations on the purchase of your new Kustom guitar amplifier.
Your KG Model draws on decades of amp design and manufacturing
experience at Kustom. This model was built from the ground up to offer
world-class tone, useful features and reliable performance. Inside this manual,
you’ll find valuable information about the amp’s controls and specifications.
Being familiar with its features will help you effectively dial in different tones.
We wish you many years of enjoyment with your Kustom amplifier.
OWNER’S MANUAL
kustom.com
KG210FX GUITAR AMPLIFIER

FCC Statements
1. Caution: Changes or modifications to this unit not expressly approved by the party
responsible for compliance could void the user’s authority to operate the equipment.
2. Note: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This equipment
generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

ENGLISH
kustom.com

FRENCH
kustom.com

1. Input: ¼-inch 2-conductor input jack that is intended for electric guitar but will accept other instruments as well.
2. Gain (Lead): Adjust this control clockwise to increase the amount of distortion. Use in its lower ranges to produce less
distorted tones. As you increase the amount of gain, the tonality will shift from a classic rock-type sound to a heavier,
modern tone.
3. Volume (Lead): This controls the overall volume level of the Lead channel only.
4. Channel: This switch selects between the Lead and Rhythm channels.
5. Volume (Rhythm): This controls the overall volume level of the Rhythm channel only.
6. Bass: This controls the bass frequencies for both channels. This passive control adjusts frequencies at 800 Hz
and below.
7. Middle: This controls the middle frequencies for both channels. This passive control adjusts frequencies between 1
and 1.5 kHz.
8. Treble: This controls the treble frequencies for both channels. This passive control adjusts frequencies at 3 kHz
and above.
9. Reverb/Delay: This switch selects between Reverb and Delay effects. Press switch in to choose Delay.
10. Effects Level: This control increases the effect signal level and mixes it with the instrument’s signal. Turn the control
clockwise to add the desired level of effects.
11. Aux In: This is a 3-conductor, 1/8-inch, stereo jack that allows playback from a Compact Disc, MP3 player or other
audio device. The overall volume level will be determined by the audio device, so start with lower volume levels and
increase as needed.
12. Headphones: This is a 3-conductor, 1/8-inch input jack intended for headphone use. The amplifier’s internal speaker
is disconnected when this jack is used.
13. Power Switch: This dual-function component is both an On/Off power switch and a status indicator light. When
illuminated, it shows that your amplifier is ready to be played. To turn amplifier on, press switch upward. To turn amp off,
press switch downward.
1234678
kustom.com
59 10 11 12 13
KG210FX Control Panel

kustom.com
External Speaker: This is a two-conductor, ¼-inch external speaker jack. (Note: This jack is wired in series with the
amp’s internal speakers. Therefore, the internal speakers still function when an external speaker cabinet is added. For
this reason, there is no minimum external speaker impedance load.)
Effects Loop Send: Use this 2-conductor, ¼-inch jack to connect to the input of an external effects processor or
equalizer. This jack can also be used as a Preamp Out.
Effects Loop Return: Use this 2-conductor, ¼-inch jack to connect to the output of an external effects processor or
equalizer. This jack can also be used as a Power Amp In. (Note: This jack separates the preamp from the power amp. If
using an external effect, the effect will be in series between the Effects Loop Send and Effects Loop Return. The amount
of “dry” signal will be controlled by the external effect.)
1. AC Power Cord Receptacle: AC power cord can be removed for easy
storage and replacement if damaged. Insert the AC cord (provided) firmly into
the AC receptacle. NOTE: Replace the AC power cord if protective jacket is
damaged or ground pin is damaged or removed.
2. Fuse: The fuse is located in a fuse tray just below the receptacle. Replace
only with the same type and size. For your convenience, a spare fuse is located
inside the fuse tray toward the front. To replace fuse, remove AC power cord.
Remove fuse tray by pulling the tab located above the fuse symbol away from
the receptacle.
KG210FX Back Panel
KG210FX AC Mains

KG210FX Suggested Settings
The following suggested settings will help you dial in a variety of popular tones. Keep in mind, these are starting points to
get you up and running with your KG amplifier. Feel free to experiment to achieve your own signature sounds.
CLEAN GUITAR
These settings are for punchy clean tones that are commonly used in Pop, Country, Alternative and many other genres
of music. Use the Rhythm channel with the tone controls set to emphasize brighter sounds. The Bass control should be
adjusted to maintain the clarity of the overall tone. Add Reverb to taste.
MEDIUM-GAIN GUITAR
These settings are appropriate for Rock, Blues or other music styles that require a moderate amount of distortion. Use
the Lead channel with the Gain set to its middle ranges. Likewise, keep the Mid control in its middle ranges but increase
the amount of Treble to maintain clarity.
HIGH-GAIN GUITAR
Try these setting ranges when you want to produce the heaviest tones. Notice that the Gain control is cranked up, the
amount of Bass is increased and Midrange is reduced for a modern, heavy-music vibe. Experiment by adding a bit of
Delay to high-gain solos.
kustom.com

Kustom®KG210FX Specifications
Output Power 20 Watts
Equalizer 3 Band Bass MiddleTreble
Channels 2
Speaker 2 x 10” 4 Ohm 15W
Effects Reverb Delay
Inputs/Outputs Aux In Head Phones
Effects Send
Effects Return
Amplifier Type Bi-Polar Transistor
Dimensions/Weight mm/Kilogram 425 (Height) X 576 (Width) X 225 (Depth),
11 Kilogram
Inches/Pounds 16.7 (Height) X 22.7 (Width) X 8.9 (Depth),
24.3 Lbs
kustom.com

kustom.com
19 November 2009
KG210FX

kustom.com

www.kustom.com
Kustom Amplification, Inc.
3015 Kustom Drive
Hebron, Kentucky
USA 41048
888-4-KUSTOM (888-458-7866)
All specifications are subject to change without prior notice. ©2009 Kustom