KuWFi CPE70R User manual

CPE70R quick Stat Guide www.kuwfi.com [email protected]
KuWFi Point-to-Point Bridge
Product picture
Pa c k a g e i n c l u d i n g ( P O E a d a p t e r w i l l b e o ff e r i n d i f fe r e n t co u n t r i e s )

CPE70R quick Stat Guide www.kuwfi.com [email protected]
Product body size :168mm*88mm*57.6mm
Working:-30°C~55°C
Storage:-40°C~70°C

CPE70R quick Stat Guide www.kuwfi.com [email protected]
Interface :
10/100Mbps RJ45 WAN Port
10/100Mbps RJ45 LAN Port
LED display, show operation mode, channel, signal strength
F(Function) switch button for LED display
S(Select) button for LED display
Reset button, press 15 seconds to revert to default setting, press 1 seco
nd to finish LED display configuration

CPE70R quick Stat Guide www.kuwfi.com [email protected]
How to paired
1. Config Master/ Slave CPE
Put the switch to H, CPE will work as Mast. Put the switch to C, CPE will
work as Slave.
2.Config Master CPE
When bridge two CPEs, make one work as master: press "F" to make H/ C b
linking, and press "S" to change to "H", it will save automatically in 5 second
s
2. Point to Point Connection Press reset button on both master and slave CP
E, will start bridging.

CPE70R quick Stat Guide www.kuwfi.com [email protected]
H mean host/master 005 mean channel, C mean Client 005 mean slave
Channel , the two unit in the same channel ,host/master IP 192.168.188.
253
Slave IP 192.168.188.100

CPE70R quick Stat Guide www.kuwfi.com [email protected]
Push and then pull the front cover out

CPE70R quick Stat Guide www.kuwfi.com [email protected]

CPE70R quick Stat Guide www.kuwfi.com [email protected]
Application 1
Long distance WiFi coverage .extend wifi signal from A house to B hous
e,like below photo show

CPE70R quick Stat Guide www.kuwfi.com [email protected]

POE adapter POE port connect to CPE Master Lan Port

CPE70R quick Stat Guide www.kuwfi.com [email protected]
Use Ethernet cable connect LAN cable to POE adapter POE adapter.
WAN port cannot charger power .