KWIK GOAL KWIK FLEX 2B1502 User manual

NZ457 Rev. 01/08/20
Parts
ASSEMBLY INSTRUCTIONS FOR 2B1502 & 2B1503 KWIK FLEX LITE GOALS
1. Unpack all parts and check for damage that may have occurred during shipping. If damage has occurred,
notify Kwik Goal immediately. Lay out all parts. Remove all cardboard and packaging immediately. Wet or
damp packaging may damage contents.
®
140 Pacific Drive Quakertown, PA 18951
800-531-4252 Kwikgoal.com
2020 Kwik Goal Ltd. ©
Goal Frame & Net (1)
Carry Bag (1) Tension Rod (4)

NZ457 Rev. 01/08/20
2. Open base frame by swinging outward until button locks
in place in center connector as shown. Use care to keep
net from getting pinched in moving parts.
Open until button locks in place
Base Frame
Base Frame
Center Connector
Base Frame
Base Frame
Center Connector
Open until button is engaged
Left Base
Left Rear Base
3. Open left and right bases by swinging outward until button
locks in place in left and right rear base.
Left Base
Right Base
Left Rear Base
Right Rear Base

NZ457 Rev. 01/08/20
4. Add tension rods to base as shown. Tension rod at front must go through net
pocket and elastic strap. Place front tension rods into base holders prior to
attaching net loops.
Tension Rod
Base
Rear Tension Rod
Front Tension Rod
Front Tension Rod
Rear Tension Rod
Net Pocket
Elastic Strap
Net Pocket
Elastic Strap

5. Connect top corners of net to tension rod in front by sliding
net loop over end of tension rod.
6. Connect backdrop corners of net to tension rod in rear
by sliding net loop over end of tension rod.
NZ457 Rev. 01/08/20
Net Loop
Tension Rod
Net Loop
Tension Rod
Go to Kwikgoal.com for additional product information.