KWIK GOAL FLEX User manual

NZ423 Rev. 02/11/19
140 Pacific Drive Quakertown, PA 18951
(P) 215-536-2200 / (P) 800-531-4252 / (F) 215-536-4309 / (F) 800-778-8869
Visit our website @ kwikgoal.com
©2017, Rev. 2019 Kwik Goal Ltd.
Parts
ASSEMBLY INSTRUCTIONS FOR 2P1901 KWIK FLEX FUTSAL GOAL
1. Unpack all parts and check for damage that may have occurred during shipping. If damage has occurred,
notify Kwik Goal immediately. Lay out all parts. Remove all cardboard and packaging immediately. Wet or
damp packaging may damage contents.
Net (1)
(Part# VZ813)
Left Base (1)
(Part# VZ725)
Right Base (1)
(Part# VZ726)
Left Rear Base (1)
(Part# VZ814)
Left Center Base (1)
(Part# VZ816)
Right Rear Base (1)
(Part# VZ815)
Center Connector (1)
(Part# VZ734)
Right Center Base (1)
(Part# VZ817)
Carry Bag (1)
(Part# VZ818)
Rear Tension Rod (2)
(Part# VZ858-03)
36-5/8”
Front Tension Rod (2)
(Part# VZ858-05)
42-1/2”
Bottom Tension Rod (4)
(Part# VZ859-03)
45”
“J” Anchor (4)
(Part# VZ786)
®

NZ423 Rev. 02/11/19
2. Open base frame by swinging outward until button locks
in place in center connector as shown. Use care to keep
net from getting pinched in moving parts.
3. Pull left and right rear base until button locks into place
on right and left center base. Do not force parts. Parts
should move freely, if parts do not, look for points where
net may be caught on frame.
Pull until button locks in place
Open until button locks in place
Base Frame
Base Frame
Center Connector
Base Frame
Base Frame
Center Connector
Pull
Pull
Left Rear Base
Right Rear Base
Right Center Base
Left Center Base

NZ423 Rev. 02/11/19
Front or Rear
Tension Rod
Bottom
Tension Rod
5. Add tension rods to base as shown.
Open until button is engaged
Left Base
Left Rear Base
4. Open left and right bases by swinging outward until button
locks in place in left and right rear base.
Left Base
Right Base
Left Rear Base
Right Rear Base
Rear Tension Rod
(Short)
Bottom
Tension Rod
Bottom
Tension Rod
Front Tension Rod
(Long)
Front Tension Rod
Rear Tension Rod
Bottom
Tension Rod
Left Base

6. Connect top corners of net to front tension rod assembly by
sliding rod cap over end of tension rod.
7. Connect backdrop corners of net to back tension rod
assembly by sliding rod cap over end of tension rod.
NZ423 Rev. 02/11/19
Rod Cap
Assembled Front
Tension Rod
Rod Cap
Assembled Rear
Tension Rod

8. Secure corner of net to left and right base with hook & loop straps as shown.
NZ423 Rev. 02/11/19
Left Base
Hook & Loop Strap
Go to kwikgoal.com for additional product information.