Kwikset Powerbolt 2 User manual

START
First, we need to confirm your lock is “ready” to
be programmed.
To be sure, let’s reset your lock.
1. Make sure the lock is in the unlocked position.
2. Remove the battery cover.
3. Press and hold the “Reset” button for 5 seconds. You will hear 3 long beeps after
the 5 seconds is completed indicating the lock has been reset.
1
A User Code is used to unlock the door while a Mastercode is a password for making changes to
the lock features.
Step 1:
Reset your lock to original settings
Interior of door
You will reset your User Code to 1-2-3-4
and Mastercode to 0-0-0-0 when the reset is
complete.
TIP
Powerbolt 2| Touchpad Keyless Entry
Programming Instructions

Programming Instructions Powerbolt 2 Touchpad Keyless Entry
2
Step 2:
Set locking and unlocking direction
1. Make sure the door is open and in the unlocked position.
2. Press 0 –0 –0 –0 – – 00 –
Note: Each button represents two numbers (i.e. ONLY push the button once for 0). If
you incorrectly enter the code, wait 10 seconds until you hear three beeps. Then you
can try again.
You may or may not see your keypad light up
orange during this step. Either way, complete the
step.
TIP
3. If the step was completed correctly, the latch bolt will extend out and retract back in
completely.
The lock will also beep twice and the keypad will
flash Green when the step is successful.
TIP
Step 2:
Set locking and unlocking direction

Programming Instructions Powerbolt 2 Touchpad Keyless Entry
3
1. Make sure the door is open and in the unlocked position.
2. Press 0
3. The latch will extend fully to the lock position and end with one beep and the keypad
will turn off.
4. Enter 1 –2 –3 –4 –
5. The latch will retract fully in the unlock position and end with one beep and the
keypad will turn off.
1. Make sure the door is open and in the unlocked position.
2. Enter the default Master Code 0 –0 –0 –0 – – 5 –
3. The lock will beep twice and the keypad will flash Green.
Step 3:
Test the Lock
Step 4:
Delete all User Codes

Programming Instructions Powerbolt 2 Touchpad Keyless Entry
4
1. Make sure the door is open and in the unlocked position.
2. Enter the default Master Code 0 –0 –0 –0 – – 7 –
3. Enter a 4 to 10 digit code and press
4. The lock will beep twice and the keypad will flash Green
If you need further assistance, please call us back at 1-800-327-LOCK (5625).
1. Make sure the door is open and in the unlocked position.
2. Enter the default Master Code 0 –0 –0 –0 – – 1 –
3. Enter a 4 to 10 digit code and press
4. The lock will beep twice and the keypad will flash Green.
Step 6:
Change the Default Mastercode
Step 5:
Program User Codes