La Crosse Technology WS8010 User manual

WS8010 Atomic Alarm Clock PAGE I 1
Model: WS8010
Instruction Manual
Atomic Alarm Clock
LCD Feature:
① ② ③ ④ ⑤ ⑥

⑦ ⑧
①Atomic time ②Alarm ③Snooze ④Low Battery ⑤Atomic Tower
⑥Month/Date ⑦Week Day ⑧Indoor Temperature
Set up：
1. Insert 3-AA LR6 batteries (not included) into the clock. Observe correct polarity.
2. Set Language,Time, Date etc.
Buttons

WS8010 Atomic Alarm Clock PAGE I 2
Settings
1.Hold the MODE button for 3 seconds to enter the setting mode
2.Press the +/- buttons to adjust the flashing values. Hold to set quickly.
3.Press MODE button to comfirm and move to next item.
Setting Order:
1.LANGUAGE 7. MINUTES
2.Beep ON/OFF 8. YEAR
3.DCF ON/OFF 9. MONTH
4.TIME ZONE +/- 12H 10.DATE
5.24/12 HOUR 11.TEMPERATURE C/F
6.HOUR
To Begin: Hold the MODE Button for 3 seconds to enter settings mode.
1. LANGUAGE
2.BEEP ON/OFF
3.DCF ON/OFF
4. TIME ZONE +/- 12H 5.24/12 HOUR

WS8010 Atomic Alarm Clock PAGE I 3
6.HOUR 7. MINUTES
8. YEAR 9. MONTH
10.DATE 11.TEMPERATURE C/F
Note:If no buttons are pressed in a 20 seconds period, set mode will time out and return to live display
mode, reflecting whatever adjustments were made by user before timed out
Set Alarm
Press and hold ALARME button to enter alarm time setting mode. The Alarm Hour will flash. Use the + or -
button to set the Hour. Press and release the ALARME button to comfirm the adjustment and move to the
next item.
Activate/Deactivate Time Alarm
 Press the ALARME button once to view the alarm time.
 Press the ALARME button again to activate the alarm.Bell icon appears.
 Press the ALARM button again to deactive the alarm .Bell icon disappears.
SNOOZE
Press SNOOZE button to slience alarm for 10 minutes. Zz will show next to the alarm bell.
Note:Alarm is crescendo sound. When the alarm sounds, it continues for 2 minute and then shuts off
completely.
Seconds or Indoor Temperature Display
Press the MODE button to select Seconds or Indoor Temperature to be displayed.

WS8010 Atomic Alarm Clock PAGE I 4
Temperature Display Second Display
Atomic Time Signal
 The station will search for the atomic time signal at 1:00,2:00,3:00,4:00,5:00
 The atomic time signal icon will flash while searching.The tower icon will solid when it has
connected .
 After reception,this station will only search for the atomic signal after midnight.
 From normal time display,press and release the « + » button to search for the DCF time signal.
 Please be sure you have selected your time zone from the list in the setting menu.When the
Atomic time signal is received ,the station will set to the time zone selected.
NOTE: All buttons will function during atomic time search.
Low Battery Icon
Low battery icon appears near date.
Specifications :
Indoor
Temperature
T
emperature range
0C to 50C (32 F to 122 F)
Power
Batteries
3XA
A
,IEC,LR6
batteries(not included)
Battery life
Battery
Life
Battery life is over 24 months when using the AC
adapter for primary power
Dimension
Dimen
sion
39.16
x
18.62
x
2.9
c
m
(
15.42
”x
7.33
”
x 1
.14
”
)
LIABILITY DISCLAIMER
 The electrical and electronic wastes contain hazardous substances. Disposal of electronic waste in wild
country and/or in unauthorized grounds strongly damages the environment.
 Please contact your local or/and regional authorities to retrieve the addresses of legal dumping
grounds with selective collection.
 All electronic instruments must from now on be recycled. User shall take an active part in the reuse,
recycling and recovery of the electrical and electronic waste.
 The unrestricted disposal of electronic waste may do harm on public health and the quality of
environment.
 As stated on the gift box and labeled on the product, reading the “User manual” is highly
recommended for the benefit of the user. This product must however not be thrown in general rubbish
collection points.
 The manufacturer and supplier cannot accept any responsibility for any incorrect readings and any
consequences that occur should an inaccurate reading take place.

WS8010 Atomic Alarm Clock PAGE I 5
 This product is designed for use in the home only as indication of the temperature.
 This product is not to be used for medical purposes or for public information.
 The specifications of this product may change without prior notice.
 This product is not a toy. Keep out of the reach of children.
 No part of this manual may be reproduced without written authorization of the manufacturer.
RED Directive 2014/53/EU
Summary of the Declaration of Conformity : We hereby declare that this wireless transmission
device does comply with the essential requirements of RED Directive 2014/53/EU.
LA CROSSE TECHNOLOGY
6A Rue du commerce
67118 GEISPOLSHEIM - FRANCE