La toulousaine 7401 User manual

N°7401

This document is the exclusive property of FTFM La Toulousaine and must on no account be copied. It may be modified at any time in accordance with product changes.

09/15

Installation manual

(Document reserved for installers)

Rack and pinion

ALUMINUM GATE

Sliding

Installation_Sliding gate_Rack and pinion_N°7401

This document is the exclusive property of FTFM La Toulousaine and must on no account be copied. It may be modified at any time in accordance with product changes.

09/15 p.2

1- Place the gate in full opening position.

2- Disengage the operator.

(Refer to the operator manual)

3- Place the rack and pinion below

the limit-switch sensor on the toothed

wheel.

Place the rack and pinion flush with

the column.

4- Drill in the 1st mark on the rack and

pinion using a Ø5 mm drill bit.

Rack and pinion installation

Installation_Sliding gate_Rack and pinion_N°7401

This document is the exclusive property of FTFM La Toulousaine and must on no account be copied. It may be modified at any time in accordance with product changes.

09/15 p.3

6- Move the gate forward to the 4th marker and then repeat steps 4 and 5 to set the rack

and pinion.

7- Continue to advance the gate then drill/fix all 4 holes by repeating steps 4 and 5 to the

end of the rack and pinion.

After you've finished fixing the rack and pinion.

8- Place the gate in the closed position and then open it again by 2 cm.

Place the stop on the rack and pinion behind and press the limit switch sensor.

2 cm

Installing the limit-switch stop

OK No

Behind In front of

Installation_Sliding gate_Rack and pinion_N°7401

This document is the exclusive property of FTFM La Toulousaine and must on no account be copied. It may be modified at any time in accordance with product changes.

09/15 p.4

9- Using the drill make 2 marks, then remove the stop and drill the rack and pinion with a

Ø5 mm drill bit.

- After drilling the hole, replace the stop and fix it to the rack and pinion with 2 sheet

metal screws TF Ø5,5 mm x 45 mm.

10- Place the gate in the open position, then close it 2 cm from the post.

Place the stop on the rack and pinion in front and press the limit switch sensor.

2 cm Position of the limit-switch stop

OK No

11- Repeat step 9 to set the limit-switch stop.

12- Re-engage the operator (Refer to the operator manual).

External view.