LabSat 3 Wideband User manual

Record
1. Connect the antenna to the ‘RF IN’ port on the
rear of the LabSat 3 Wideband.
www.labsat.co.uk
Quick Start Guide
2. Place the antenna in the middle of the car roof.
3. Ensure you have selected the correct record
settings (i.e. quantisation, bandwidth,
frequency).
4. Press the ‘REC’ button to start recording.
5. Drive the desired route.
TIP: Record at least 4 minutes of stationary data to allow for
acquisition later.
6. Press the ‘REC’ button again to stop recording.

www.labsat.co.uk
Quick Start Guide
Replay
1. Connect the Device Under Test to the
‘RF OUT’ port.
2. Use the up and down arrows to select the
desired scenario.
TIP: Four demo scenarios are pre-loaded on the SSD.
3. Press the ‘Play’ button. 4. The Device Under Test should now be receiving
the replayed satellite signal data, allowing
realistic and repeatable testing to be carried
out under controlled conditons.