7
Instructions and Installation
Before using your fridge freezer for the first time, please pay attention to the following points:
• The operating voltage for your fridge freezer is 220-240 V at 50Hz.
• The plug must be accessible after installation.
• Your fridge freezer may have an odour when it is operated for the first time. This is normal and the odour
will fade when your fridge freezer starts to cool.
• Before connecting your fridge freezer, ensure that the information on the data plate (voltage and
connected load) matches that of the mains electricity supply. If in doubt, consult a qualified electrician.
• Insert the plug into a socket with an efficient ground connection. If the socket has no ground contact or the
plug does not match, we recommend you consult a qualified electrician for assistance.
• The appliance must be connected with a properly installed fused socket. The power supply (AC) and
voltage at the operating point must match with the details on the name plate of the appliance (the name
plate is located on the inside left of the appliance).
• We do not accept responsibility for any damages that occur due to ungrounded usage.
• Place your fridge freezer where it will not be exposed to direct sunlight.
• Your fridge freezer must never be used outdoors or exposed to rain.
• Your appliance must be at least 50 cm away from stoves, gas ovens and heater cores, and at least 5 cm
away from electrical ovens.
• If your fridge freezer is placed next to a deep freezer, there must be at least 2 cm between them to prevent
humidity forming on the outer surface.
• Do not cover the body or top of fridge freezer with lace. This will affect the performance of your fridge
freezer.
• Clearance of at least 150 mm is required at the top of your appliance. Do not place anything on top of your
appliance.
• Do not place heavy items on the appliance.
• Use the adjustable front legs to make sure your appliance is level and stable. You can adjust the legs by
turning them in either direction. This must be done before placing food in the appliance.
• Clean the appliance thoroughly before use (see Cleaning and Maintenance).
• Before using your fridge freezer, wipe all parts with a solution of warm water and a
teaspoon of sodium bicarbonate. Then, rinse with clean water and dry.
Return all parts to the fridge freezer after cleaning.
• Install the two plastic distance guides (the parts on the black vanes condenser - at
the rear) by turning it 90° (as shown in the figure) to prevent the condenser from
touching the wall.
• The distance between the appliance and back wall must be a maximum of 75 mm.
• The product is not designed to be used in very low temperature environments such
as garages or sheds.
The thermostat control will not work correctly (unless it is designed to work in these
environments)
Installing and Operating your Fridge Freezer
Before Using your Fridge
• When using your fridge for the first time, or after transportation, keep it in an upright position for at
least 3 hours before plugging into the mains. This allows efficient operation and prevents damage to the
compressor.
• Your fridge may have a smell when it is operated for the first time. This is normal and the smell will fade
away when your fridge starts to cool.
These new-generation products can create an array of sounds / noises during their normal daily operation.
Noises
