
5
General Information
• This grill is designed to be used with a standard 20
lb. LP gas cylinder.
• Any brand of 20 lb. LP gas cylinder is acceptable
for use on this grill, provided that it is compatible
with the grill’s retention means (tank tray bolt).
• This grill is designed certified by ETL international
for local LP gas supply.
Safety Information
• LP gas has an odor similar to natural gas.
• LP gas is heavier than air and leaking gas may
collect in low areas and resist dispersion.
• LP cylinders must be installed, transported and
stored in an upright position.
• LP cylinders should not be dropped or handled
roughly.
• DO NOT use a damaged LP cylinder. A dented or
rusty LP cylinder or an LP cylinder with a damaged
valve may be hazardous and should be replaced
with a new cylinder immediately.
•ALWAYS close the cylinder valve after use.
• ALWAYS close the cylinder valve when
disconnecting the regulator.
• ALWAYS treat possible empty LP cylinders with
the same care as a full LP cylinder. There may
still be gas pressure inside a possible empty LP
cylinder.
• NEVER store or transport an LP cylinder where the
temperature can reach 125ºF.
• Keep LP cylinders away from children and pets.
• DO NOT store disconnected LP cylinders in a
building, garage or other enclosed areas.
• If the LP cylinder is kept in the grill between uses,
make sure to keep both the grill and the cylinder in
an outdoor area with good ventilation.
• ALWAYS leak test the LP cylinder connection to
the regulator whenever changing LP cylinders.
Installation of LP Cylinder
1. Maker sure all burner controls are in the • OFF
position.
2. Open the cabinet door.
3. Carefully position in the large hole on the bottom
panel.
4. To secure the LP cylinder in place, screw the tank
holding tray bolt through the bottom section of the
LP cylinder.
5. Attach the regulator to the cylinder by carefully
HAND TIGHTENING only.
6. NEVER use a wrench or other tool to tighten this
connection.
7. Observe all governing codes and ordinances.
Important
The United States LP gas appliance installation must
conform with local codes and ordinances. In the
absence of local codes, appliance installation must
conform with either the National Fuel Gas Code, ANSI
Z223.1/NFPA54, Natural Gas and Propane Appliance
code, CSA B149.1, or Propane Storage and Handling
Code, B149.2, as applicable.
For Canada, installation of this grill must comply with
local codes and/or Standard CSA-B149.2 (Propane
Storage and Handling Code).
Liquid Propane (LP) Safety Information
Please review the below guidelines and safety information when using Liquid Propane (LP) gas.
Always check the rating plate to verify that
the appliance is the correct gas type for the
gas supply that you are connecting to. A
natural gas grill requires natural gas to
operate and an LP gas grill requires liquid
propane to operate.
The rating plate can be found on the bottom
of the grill control panel.
7405 Graham Road, Fairburn, GA 30213
www.landmann-professional.com
800-321-3473
Made in China
Model No.: 43106
Type of Gas: Propane (LP)
Main burner: 12,000 BTU/HR
WARNINGS & CAUTION:
FOR OUTDOOR USE ONLY . If stored indoors, detach and leave cylinder outdoors.
Use only the gas pressure regulator supplied with this appliance.
This regulator is set for an outlet pressure of 10” W.C.
Turn off LP supply at cylinder when appliance is not in use.
a. Do not store a spare LP-gas cylinder under or near this appliance.
b. Never fill the cylinder beyond 80 percent full;
If the informaon in (a) and (b) is not followed exactly, a fire causing death or serious injury may
occur. Do not use this appliance under over head combustible surfaces.
Only for Installaon in a Built-in enclosure constructed of non-combusble materials. Minimum
clearance from side and back of unit to combusble construcon: 36” from sides and back.
XXXXXX Conforms
to ANSI STD Z21.58-2015 Cerfied
to CSA STD 1.6 2015 Outdoor
Cooking Gas Appliance
Serial Number: XXX
Rating Plate