Larco Jamb User manual

www.larco.com
Jamb Switch Box
Installation Instructions
2
3
4
5
7
6
1Determine switch mounting location based on wall or construction,
applicable standards and intended use.
Punch out holes in the jamb box in the areas provided. Use caution and do
not damage any electronics present in the box.
Drill holes in mounting surface using the mounting box as the template. In
hardwired installations, drill a wiring access hole.
Insert the appropriate fastener through the box and into the mounting
surface and tighten securely. Make sure the box is mounted flat, not
twisted.
In hardwired installations, wire the jamb switch to the door controller
using spade terminals to connect to the NO and COMMON contacts. A
knockout area is provided for routing switch wires into the box. For radio-
controlled installations, wire the jamb switch to the transmitter using the
NO and COMMON contacts.
Use the enclosed wrench to tighten the #6-32 screws into the jamb box
(as shown in the top drawing on right).
Test for proper operation.
Directions
Jamb Box Assembly
Hollow Wall Mounting
Observe all manufacturers’ recommendations for safety and operation of their
products. ANSI/BHMA standards that offer specific recommendations for each type
and class of automatic door have been developed. To obtain a copy of the ANSI/
BHMA standard that applies to the installation, visit www.buildershardware.com
or www.ansi.org.
DELUXE JAMB SWITCH
JAMB SWITCH
MOUNTING BOX
JAMB SWITCH BOX
JAMB
SWIT
CH
MOUNTING
SCREW
MOUNTING SURFACE

ATEK Access Technologies
10025 Valley View Road, Ste. 190
Eden Prairie, MN 55344 U.S.A.
PH: 1.800.523.6996
FAX: [phone]
+1.218.829.9797
www.atekaccess.com
1-1/4"
3-3/8"
3-3/4"
DRILL 7/64" AND TAP (2 PLACES )
FOR #6-32 MACH. SCREW
FOLD ON DOTTED LINES
FOR 1-3/4" JAMB TEMPLATE
1-1/4" X 3-3/8"
CUTOUT
TIGHTEN SCREWS THROUGH HOLES
IN COVER PLATE WITH
HEX KEY PROVIDED
18 GA WIRE
MAX.
Jamb Switch
Installation Instructions
223-0132-000 Rev. E 5/15