8RECORD TO USB
Insert USB
FAT32
32GB
exFAT
NTFS
Use to adjust
value on screen
Tap to set desired ALARM source
e.g. CD, FM or USB
1
OK after adjusting
2
Tap to select function
to RECORD from
CD, FM, BT or AUX
1
Tap to start
RECORDING
2
When recording
from CD tap REC
to swap between
RECORD 1 TRACK
or RECORD ALL
Tap to STOP anytime
to FINISH or let CD
playthrough ALL to
STOP automatically
For more
helpful guides
visit us at
LASER
www.youtube.com/LasercoAu
WARRANTY
Our goods come with guarantees that cannot be excluded under the Australian Consumer Law. You are entitled to a replacement
or refund for a major failure and compensation for any other reasonably foreseeable loss or damage. You are also entitled to have
the goods repaired or replaced if the goods fail to be of acceptable quality and the failure does not amount to a major failure.
www.laserco.com.au
No Power:
1. Check power cable is connected properly and
tap power button to turn on. If there is rd light
next to power button then it means device is
still in STANDBY
2. If using batteries make sure power cable is
not connected
Radio not clear:
1. Change speaker location
2. Isolate from other devices as this may be
caused by interference from other devices
USB drive not working or
files not playing from USB:
1. Check USB drive is formatted
to FAT32 file system
2. Make sure only using MP3 files
copied to the USB drive
TROUBLESHOOTING
OK after adjusting
1
Switch between HOURS and MINUTES
2
Save OFF TIMER
3
