Lasertec LDH3 User manual

INSTRUCTION MANUAL
LDH3
HYBRID DETECTOR AND CLAMP

2
Read the following safety instructions before attempting to operate
this product.
SAVE ALL WARNINGS AND INSTRUCTIONS FOR FUTURE
REFERENCE.
WARNING: Read and understand all instructions.
▪ Use the detector only with the specically designated battery.
▪Store the detector out of reach of children and other untrained
persons.
▪Use only accessories that are recommended for your model.
▪ Tool service must be performed only by qualied repair personnel.
Repairs, service or maintenance performed by unqualied personnel
will void the warranty. Only approved and authorised service
technicians can carry out warranty repairs.
WARNING: DO NOT DISASSEMBLE THE DETECTOR.
There are no user serviceable parts inside. Disassembling the
detector will void all warranties on the product. Do not modify the
product in any way.
SAFETY
!
!

Lasertec LDH3 detector Sta clamp
Alkaline battery
3
Please ensure the following items are included with your
detector. If anything is missing please contact your retailer.
ITEM CHECKLIST

4
PRODUCT OVERVIEW
DETECTOR FRONT
Bubble vial
Sensor panel
LED direction indicator
LED direction indicator
LED power indicator
LED speaker indicator
LED centre indicator
Bubble vial
Speaker
Power on / off
Speaker on / off

5
DETECTOR BACK
Staff clamp thread
LED direction indicator
LED direction indicator
Battery compartment
Battery compartment screw
LED centre indicator

6
USING YOUR DETECTOR
POWER SUPPLY
SET UP
OPERATION
▪The instrument is supplied with one 9v alkaline battery as its
standard power source.
Removing & inserting the alkaline battery
▪Unscrew the battery compartment screw and remove the battery
cover door and the battery.
▪Insert the battery according to polarity and replace the battery door.
Powering on
▪Switch the detector on by pressing the power button. The speaker
will emit a small tone to indicate the instrument is operating.
Mounting the staff clamp
▪Insert the staff clamp screw into the staff clamp thread.
▪Rotate the nut until the clamp is secured in place.
Speaker function
▪ Press the speaker button to turn the speaker off. Press again to
turn the speaker on and cycle between the speaker volumes.
Operation with a multi-line laser level
▪Move the detector into the path of the laser beam.
▪Hold the detector upright for horizontal beams or rotate 90° for
vertical beams.
▪The LED direction indicators will indicate the position of the laser
beam. The centre LED will indicate alignment with the beam.
This instrument is compatible with all Lasertec red and green
beam multi-line laser levels with detector capability and
most 3rd party red and green beam laser levels with detector
capability. Check the instruction manual of your laser level for
more information on setting up the laser level for detecetor use.
i

7
USING YOUR DETECTOR
Detector position for horizontal beams
Detector position for vertical beams

8
The Lasertec LDH3 comes with a 1 year manufacturers warranty.
AUSTRALIA
"Our goods come with guarantees that cannot be excluded under the
Australian Consumer Law. You are entitled to a replacement or refund
for a major failure and for compensation for any other reasonably
foreseeable loss or damage. You are also entitled to have the goods
repaired or replaced if the goods fail to be of acceptable quality and
the failure does not amount to a major failure."
For more information please visit consumerlaw.gov.au
NEW ZEALAND
For more information please visit consumerprotection.govt.nz
To assist you with any queries or technical questions please contact
customer support
Australia: 1300 658 338
New Zealand: 0800 367 527
CUSTOMER SUPPORT
WARRANTY

9
SPECIFICATIONS
Specications Lasertec LDH3
Product code 91820
Warranty 1 Year
Speaker decibel (maximum) 70
Battery type 1x 9v
Weight (kg) 0.159
Dimensions (mm) 159 x 55 x 20

www.spoton.com.au