Laura Ashley ASHWELL User manual

1
Laura Ashley
ASHWELL Bed
Thank you for purchasing this product. Please read the instructions carefully before use to ensure safe and
satisfactory operation of this product.
Please ensure instructions are read in full before commencing with this product.
Allen Key included)
Necessary Tools:
Please check the pack contents before you begin. A full checklist of components is given in this leaflet. If any
components are missing, please contact the retailer from whom you bought this product.
- Do not stand or lean on this product.
- Make sure the area is clear when unpacking and positioning this product.
This product is heavy, it should be assembled as near as possible to the point of use.
Take care when lifting to avoid personal injury and or damage to the product.
- Keep small children/pets away from assembly area. This product has small component parts that are a
choking hazard.
- Make sure you assemble this product correctly as per the instructions and ensure all fittings are tight.
- A minimum of two persons is require to lift the Bed into position
- We recommend that the packaging is used to protect the surfaces during assembly.
Safety Advice and Assembly Recommendations

2
Fittings and parts checklist
A Bolt x 12 D Allen Key x 1
B Screw Ø 3.5 x25
x 12
C
Dowel x 8
Step by step assembly instructions
A minimum of two persons is required to assemble this product.
Step One
- Attach Side Rails to Headboard
-
Step Two
- Attach Side rail to the Footboard using Bolt

3
Step Three
Repeat step two with the other side rail, than connect the side rails to the footboard and assembly in the
same manner
Step Four
Fit 2 x Adjustable Support Legs onto Centre Rail , aligning corresponding holes.
Step Five
Fit metal brackets on each end of Centre Rail into each metal brackets on Headboard &
Footboard. Firmly press each into position until brackets are fully engaged.

4
Step Six
Attach 8 Wood Dowels to 2 x Side Rails
Place the Slat assembly onto support ledge of each Side Rail and Centre Rail .
aligning holes in slats with the holes in support ledges. Secure with 12 Screws, fully tighten
all screws with screwdriver.
Step seven
Repeat with the other Slat support
To compensate for uneven floors, adjust levelers on adjustable support legs, as necessary.
Care and Maintenance. Please refer to Laura Ashley Care Guide
PLEASE KEEP THESE INSTRUCTIONS FOR FUTURE REFERENCE
If you have any queries with this product please contact
Laura Ashley Customer Services. Tel: [phone]
www.lauraashley.com