LCI OneControl User manual

OneControl®
Bluetooth Switch
OEM INSTALLATION MANUAL

Rev: 11.26.19 Page 2 CCD-0002707
TABLE OF CONTENTS
Introduction 2
Safety 2
Resources Required 2
Installation 3
Introduction
This document explains how to install the wireless switches which pair to the OneControl® controller. The
controller MUST be equipped with bluetooth capability that allows the controller to operate different
functionalities. The bluetooth switches are OPTIONAL equipment. OneControl® Bluetooth Switches come in
2, 4, 5 and 6 button configurations with various preassigned functions.
For information on the assembly or individual components of this product, please visit:
https://support.lci1.com/electronics-support-onecontrol-wireless-formerly-myrvreg .
NOTE: Images used in this document are for reference only when assembling, installing and/or operating
this product. Actual appearance of provided and/or purchased parts and assemblies may differ.
Safety
Contact LCI Customer Service if there are questions or concerns about the procedures in the manual.
This manual provides general instructions. Many variables can change the circumstances of the instructions,
i.e., the degree of difficulty, operation and ability of the individual performing the instructions. This
manual cannot begin to plot out instructions for every possibility, but provides the general instructions,
as necessary, for effectively interfacing with the device, product or system. Failure to correctly follow the
provided instructions may result in death, serious personal injury, severe product and/or property damage,
including voiding of the LCI limited warranty.
Resources Required
• Cordless or electric screw gun
• Assorted drill bits
• Phillips head bit or screwdriver
• Flat head screwdriver
• Pen or pencil
• Bullet level

Rev: 11.26.19 Page 3 CCD-0002707
Installation
NOTE: Installation location of the bluetooth switches will vary by OEM and the floor plan of a particular unit.
NOTE: Remove red tab on the back of the switch in order to activate the battery (Fig. 1). In the event that it
is necessary to replace the batteries, the switch requires two (2) CR 2032 batteries.
1. Using the tip of a flat head screwdriver, remove the switch cover from the mounting plate by inserting
the tip into the side slot of switch and pry open (Fig. 2A).
Fig. 1
2. With the switch cover removed, position the mounting plate in the predetermined location on the wall.
3. Check the mounting plate for level using a bullet level.
4. Using a pen or pencil mark the location of the four mounting holes located in each corner of the
mounting plate (Fig. 3).
Fig. 2
A
Mounting
Hole
Mounting
Hole
5. Using an electric or cordless drill, attach the mounting plate onto the wall with four #2 wood screws.
Do not over-tighten screws. Over-tightening screws may cause cracking in the mounting plate.
6. Reattach the switch cover.
Fig. 3

The contents of this manual are proprietary and copyright protected by Lippert Components, Inc. (“LCI”).
LCI prohibits the copying or dissemination of portions of this manual unless prior written consent from an
authorized LCI representative has been provided. Any unauthorized use shall void any applicable warranty.
The information contained in this manual is subject to change without notice and at the sole discretion of LCI.
Revised editions are available for free download from lci1.com.
Please recycle all obsolete materials.
For all concerns or questions, please contact
Lippert Components, Inc.
Ph: [phone] | Web: lci1.com | Email: [email protected]