LeakAlertor 6000 User manual

RESET
BUTTON
The LeakAlertor that was installed for you is a
smart device that electronically monitors your
toilet for water wasting problems. When a
problem is detected, you will be alerted both
visually and audibly…
…before you leave the bathroom.
Warning: Removing the unit from the toilet
will cause a continuous alert to sound until
the unit is placed back in the tank.
Note: The LeakAlertor does not contain a
camera or any type of recording device.
For repairs and service, please contact:
RESET
BUTTON
The LeakAlertor that was installed for you is a
smart device that electronically monitors your
toilet for water wasting problems. When a
problem is detected, you will be alerted both
visually and audibly…
…before you leave the bathroom.
Warning: Removing the unit from the toilet
will cause a continuous alert to sound until
the unit is placed back in the tank.
Note: The LeakAlertor does not contain a
camera or any type of recording device.
For repairs and service, please contact:
RESET
BUTTON
The LeakAlertor that was installed for you is a
smart device that electronically monitors your
toilet for water wasting problems. When a
problem is detected, you will be alerted both
visually and audibly…
…before you leave the bathroom.
Warning: Removing the unit from the toilet
will cause a continuous alert to sound until
the unit is placed back in the tank.
Note: The LeakAlertor does not contain a
camera or any type of recording device.
For repairs and service, please contact:

Manufactured by:
nth Solutions, LLC
LA6KLB AUG17
When the GREEN LIGHT –and only
the GREEN LIGHT –is flashing during
a flush, your toilet is functioning
properly.
BUT…
If the LeakAlertor only beeps a few times
whenever the toilet is flushed, please call
the contact number during normal
business hours at your earliest
convenience.
…If the LeakAlertor is continuously
beeping and flashing the RED LIGHT,
immediately take the following action:
1) Shut off the water by
turning this knob
clockwise as far as
possible.
2) Press the reset button to
temporarily silence the
LeakAlertor.
3a) If the toilet was over-
flowing, first remove the
blockage. Then, turn the
water back on by turning the
knob fully counter-clockwise.
3b) If the toilet was only
running, remove the tank lid
and close the flapper by
making sure it lays flat, as
shown here. Once the
flapper has been closed, turn
the water back on.
For more information and videos about the LeakAlertor, visit
www.leakalertor.com
Manufactured by:
nth Solutions, LLC
LA6KLB AUG17
When the GREEN LIGHT –and only
the GREEN LIGHT –is flashing during
a flush, your toilet is functioning
properly.
BUT…
If the LeakAlertor only beeps a few times
whenever the toilet is flushed, please call
the contact number during normal
business hours at your earliest
convenience.
…If the LeakAlertor is continuously
beeping and flashing the RED LIGHT,
immediately take the following action:
1) Shut off the water by
turning this knob
clockwise as far as
possible.
2) Press the reset button to
temporarily silence the
LeakAlertor.
3a) If the toilet was over-
flowing, first remove the
blockage. Then, turn the
water back on by turning the
knob fully counter-clockwise.
3b) If the toilet was only
running, remove the tank lid
and close the flapper by
making sure it lays flat, as
shown here. Once the
flapper has been closed, turn
the water back on.
For more information and videos about the LeakAlertor, visit
www.leakalertor.com
Manufactured by:
nth Solutions, LLC
LA6KLB AUG17
When the GREEN LIGHT –and only
the GREEN LIGHT –is flashing during
a flush, your toilet is functioning
properly.
BUT…
If the LeakAlertor only beeps a few times
whenever the toilet is flushed, please call
the contact number during normal
business hours at your earliest
convenience.
…If the LeakAlertor is continuously
beeping and flashing the RED LIGHT,
immediately take the following action:
1) Shut off the water by
turning this knob
clockwise as far as
possible.
2) Press the reset button to
temporarily silence the
LeakAlertor.
3a) If the toilet was over-
flowing, first remove the
blockage. Then, turn the
water back on by turning the
knob fully counter-clockwise.
3b) If the toilet was only
running, remove the tank lid
and close the flapper by
making sure it lays flat, as
shown here. Once the
flapper has been closed, turn
the water back on.
For more information and videos about the LeakAlertor, visit
www.leakalertor.com