LED-supplies flood-10w-stand User manual

Issue 2013
10W Standard LED Floodlight With Stand
These instructions are provided as a guideline to assist you.
PLEASE READ THESE INSTRUCTIONS BEFORE INSTALLATION
AND RETAIN FOR FUTURE REFERENCE
Pack contents:
1 x Fitting
INSTALLATION INSTRUCTIONS
A guide for qualied electricians
874/2012
MODELNO.
LAMP SPECIFICATIONS:
Nominal useful luminous ux 700 lm
Rated Wattage 10W
Rated luminous ux 700 lm
Nominal life time of the lamp 30,000 hrs
Colour temperature 6200K
Number of switching cycles
before premature lamp
failure
≥17,500
Warm-up time up to 60 % of
the full light output Instant full light
Dimmable No
Lamp dimensions (W/D/H) 115x100x85mm
Nominal beam angle 120°
Rated power 10W
Rated lamp lifetime 30,000
Lamp power factor >0.5
Lumen maintenance factor at
end of nominal life ≥0.8
Starting time <0.5
Colour rendering ≥0.75
Colour consistency Within 6 step
Macadam ellipse
Rated peak intensity 327cd
Rated beam angle 120°
EVENTUALLY, YOU MAY WANT TO
REPLACE THIS PRODUCT:
Regulations require the recycling of Waste from
Electrical and Electronic Equipment (European
“WEEE Directive” eective August 2005—UK
WEEE Regulations eective 2nd January 2007).
Environment Agency Registered Producer:
WHEN YOUR PRODUCT COMES TO THE END OF
ITS LIFE OR YOU CHOOSE TO REPLACE IT, PLEASE
RECYCLE IT WHERE FACILITIES EXIST  DO NOT
DISPOSE WITH HOUSEHOLD WASTE.
CLEANING:
Clean this tting only with a soft dry cloth.
Do not use any chemical or abrasive cleaners.
IF YOU EXPERIENCE PROBLEMS:
If you believe your product is defective, please return
it to the place where you bought it. Our Technical
Team will gladly advise on any
product, but may not be able to give specic
instructions regarding individual installations.
For breakage information visit:
0.5M

READ THIS FIRST:
Check the pack and make sure you have all of the
parts listed on the front of this booklet. If not,
contact the outlet where you bought this product.
This product contains glass, care must be taken when
handling to prevent personal injury or damage to the
product.
This product must be installed / used by a competent
person in accordance with the current building and
IEE wiring regulations.
As the buyer, installer and/or user of this product it
is your own responsibility to ensure that this tting
is t for the purpose for which you have intended
it. cannot accept any liability for
loss, damage or premature failure resulting from
inappropriate use.
This product is designed and constructed according
to the principles of the appropriate British Standard
and is intended for normal domestic service.
This unit is suitable for both indoor and outdoor use.
If used in an outdoor environment the mains plug
must be housed in a suitable IP enclosure.
Do not use this portable oodlight in the immediate
surroundings of a bath, shower, or swimming pool.
Do not use the oodlight in any areas where
petrol, paint or other ammable liquids or
ammable fumes may be present.
If the portable oodlight is being used in an
outhouse etc, it should be protected by an ELCB /
30mA RCD.
This portable light should be positioned at least 0.5M
(500mm) away from highly ammable surfaces (e.g.
polystyrene, textiles).
This product comes pre-wired and comes tted with
a 3 pin UK 13 amp plug & suitable fuse. The tting is a
class 1 so should always be earthed.
Do not cover the tting with any materials when in
use.
This product is not intended to be used by children
and persons with sensory, physical and/or mental
impairments that would prevent them from using it
safely.
Small children should be supervised to ensure that
they do not play with this portable light.
IMPORTANT: Always switch o at the socket before
removing the plug.
The plug is tted with a suitable fuse. When
replacing, use only a suitable fuse approved to
BS1362 and carrying the relevant approval mark.
Never use the plug with the fuse bypassed or
omitted. If the external exible cable of this
luminaire is damaged it shall be exclusively replaced
by a service agent or similar qualied engineer.
USAGE:
The product comes fully assembled and prewired
with 2M of cable and tted with a 3 pin plug. The
head can be adjusted by loosening the bolts, re
tighten with the aid of a spanner once in the correct
position. Insert plug in mains socket and switch on
the light to illuminate.
WARNING:
Arrange the cord away from high trac areas and
where it will not become a trip hazard.
• Do not use the oodlight in any areas where petrol,
paint or other ammable liquids or ammable
fumes may be present.
• Do not use this oodlight in the immediate
surroundings of a bath, shower, swimming pool or
where water is present.
LAMP REPLACEMENT:
This luminaire has a sealed LED lamp and is
maintenance free, no lamp replacement is required.
Head can be adjusted by
loosening these bolts
Frame can be adjusted by
loosening this knob