LEGRAND F521 User guide

0 035 66
Energy Data Logger
Installer manual
06/12-01 PC

2

Energy Data Logger
Contents
3
Installer manual
1 Description 4
1.1 Warnings and recommendations 4
1.2 Main functions 4
1.3 Legend 5
2 Connection 6
2.1 Wiring diagrams 6
3 Configuration 7
3.1 Procedure with Windows 2000 or XP operating system 7
3.2 Procedure with Windows Vista or 7 operating system 16
3.3 Procedure for Tablet and Smartphone 22
3.4 Troubleshooting 22
4 Appendix 23
4.1 Technical data 23

4
1.1 Warnings and recommendations
Before proceeding with the installation we recommend that you read the content of this manual
very carefully.
The warranty will automatically become void in case of negligence, improper use, and tampering
by unauthorised personnel.
1 Description
1.2 Main functions
The SCS device saves the consumption values in separate energy lines. These lines can be both
electric, by connecting Bus meters with 3 inputs for toroids, item F520, or a load management
central unit, item F521, and non-electric, by connecting pulse counter interfaces, item 3522. The
total number of lines managed cannot exceed 10.

Energy Data Logger
5
Installer manual
1 - User interface LED: see table
2 - MicroSD memory card slot (optional)
3 - Connection to the SCS BUS
4 - Ethernet connection
5 - Reset key:
– press and hold for 10 seconds to restart the Energy Data Logger;
– press and hold for 20 seconds to restart the Energy Data Logger , and set the dynamic
selection of the IP address.
1.3 Legend
User interface LEDs table
Red LED
flashing slowly and regularly:
no network found;
waiting for an address to be assigned.
Green LED
flashing slowly and regularly: device waiting to be configured.
Green LED
flashing quickly and regularly: time on the device not configured.
Green LED
flashing slowly and irregularly: device working and configured.
Red-green LED
flashing quickly:
IP or microSD configuration error.
Reset, check the configuration, and the microSD
memory card model.
4
2
1
2
3
1
5
5
3

6
Check that your PC is set for automatic acquisition of the IP address (network parameters);
then select the Energy Data Logger device among the network resources.
2 Connection
Diagram with direct or crossover cable
2.1 Wiring diagrams
To put the device into operation, this must be connected following the diagrams below.
Diagram with switch
BUS
BUS
Switch / router

Energy Data Logger
7
Installer manual
3.1 Procedure with Windows 2000 or XP operating system
If the connection is correct, it will be possible to display the device in the My Network Places
window, with the name “Energy Data Logger”.
3 Configuration
The Web pages can be accessed with two authority levels: “user" and as “administrator”.
In addition to having access to the same pages as the user, the administrator can also
access the “Configuration” function and define some Data Logger parameters. Ask your
installer for the access passwords, if this has not already been provided.
To learn how to navigate through the web pages refer to the user manual.
Double click on the icon to open the configuration WEB page.

8
1
From the Start / Control panel menu
1 - Click "Windows Firewall".
If the device is not automatically recognised by the PC, follow the instructions below. To access
the configuration page, and display the device IP address, the following parameters must be set:
3 Configuration

Energy Data Logger
9
Installer manual
4
2 - Select “Exceptions”.
3 - Enable "UPnP Framework".
3
2
From the
Start / Control panel menu
4 - Click “Add or Remove
Programs”.

10
5 - Click “Add/Remove
Windows components”.
5
6 - Enable “Networking
services”
7 - Click “Details”.
6
7
3 Configuration