Lencore G420 User manual

Jordna Hub
INSTALLATION &
OPERATIONS
MANUAL

1) Read these instructions.
2) Keep these instructions.
3) Heed all warnings.
4) Follow all instructions.
5) Do not use this apparatus near water.
6) Clean only with dry cloth.
7) Do not block any ventilation openings. Install in accordance with the manufacturer's
instructions.
8) Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus
(including amplifiers) that produce heat.
9) Only use attachments/accessories specified by the manufacturer.
10) Refer all servicing to qualified service personnel. Servicing is required when the apparatus has
been damaged in any way, such as power-supply cord or plug is damaged, liquid has been
spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or
moisture, does not operate normally, or has been dropped.
1
important
safety instructions

The following guide will provide you basic installation instructions for the Jordna Hub
The Jordna Hub is used when installing a Lencore i.Net Sound Masking System and there is no music or paging
required on the installation.
The Jordna hub is used for:
– Wire management
– Wire breakout
– System expansion
The below diagram demonstrates standard connectivity of the G8350 Headend, Jordna Hub and theOperating Platform
Instructions
1. Using a CAT cable connect the G8350 Headend's "TO OP" port to the DATA IN port on the JORDNA Hub.
2. Connect a standard CAT cable from one of the four available DATA OUT ports to the first OP.
JORDNA HUB INSTALLATION INSTRUCTIONS
2

JORDNA HUB INSTALLATION INSTRUCTIONS
MOUNTING THE JORDNA HUB:
Using (4) #6 x ½” flat head screws, securely mount the Jordna Hub to the wall.
3

Lencore Acoustics LLC.
516-682-9292
[email protected]
www.lencore.com
The information contained herein is proprietary to Lencore Acoustics LLC. and copyright protected. No part of this manual
can be copied, used or distributed without prior authorization from Lencore Acoustics LLC. ©Copyright 2021