Lenoxx PR4172 User manual

1
Model no: ICM18
Batch no: PR4172
INSTRUCTION MANUAL
Please read and retain instructions for future reference.
This appliance is intended for household use only.

2
The Lenoxx ICM18 is a handy addition to your household and provides an ideal helper to ensure you have a ready
supply of ice to cater to the demands of entertaining. Perfect for keeping refreshing drinks cool and the party going,
you’ll never need to duck out to buy a bag of ice again. Producing a whopping 10 Kg of ice every 24 hours, it also
features a 600g ice bin capacity and 1.7 Litre water reservoir. Simple and easy to use, with LED indicators, simple
control panel for easy use and audible alarms for water shortage and ice bin full, ensuring your cool drinks stay
cold and the party doesn’t end.
IMPORTANT SAFEGUARDS
Please read and retain these instructions for future reference.
• Remove and safely disregard any packaging material and labels before using this product for the first time.
Ensure children and babies do not play with plastic bags or any packaging materials
• Before using the ice maker for the first time, let it sit for 2 hours with the lid open.
• Ensure that the voltage indicated on the ice maker corresponds with the voltage in your home.
• Do not operate any appliance with a damaged cord or plug or after the appliance malfunctions or is
dropped or damaged in any manner, take it to the store where the unit was purchased or call Lenoxx
customer service for further assistance on 1300 666 848.
• Unplug the ice maker from the power outlet when it is not in use, before putting or taking parts off and
before cleaning.
• Do not let the cord hang off the edge of a bench, table or touch a hot surface.
• The use of accessories not recommended by the manufacturer may cause injuries to persons.
• This appliance is not intended for used by persons (including children) with reduced physical, sensory or
mental capabilities, or lack of experience and knowledge, unless they have been given supervision or
instruction concerning use of the appliances by a person responsible for their safety.
• Children should be supervised to ensure that they do not play with the appliance
• Cleaning and user maintenance shall not be made by children without supervision.
• This appliance is intended to be used in household and similar applications such as:
-staff kitchen areas in shops, offices and other working environments;
-farm houses;
-by clients in hotels, motels and other residential type environments;
-bed and breakfast type environments
• Do not operate the ice maker other than for its intended use.
• The ice maker is to be used horizontally and on a stable surface.
• Do not position this appliance on an incline over 45 degrees.
• Do not put the ice maker upside down as this may damage the compressor and sealed system.
• For proper ventilation, keep 15 cm clearance around the ice maker on each side, the rear and the top.
• Do not use the ice maker close to open flames, hot plates or stoves.
• Do not immerse the ice maker in water.
• Fill with drinking water only.
• Before use, ensure the silicone stopper is inserted correctly.

3
PARTS
1.Silicon stopper
2.Water tank
3.Compressor
4.Plug and power cord
5.Front lid
6.View window
7.Back front cover
8.Control Panel
9.Water tray
10.Evaporator
11.Ice shovel
12.Scoop (Please find it in the package for manual)
13.Ice basket
CONTROL PANEL
ON/OFF: Press to turn the ice maker on or off.
ADD WATER: This light will come on with an alarm to let you know more water is required. You will need to add
water and press the 'ON/OFF' button to restart the Ice maker.
ICE FULL This light will come on with an alarm to let you know when the ice has reached the maximum capacity of
the storage cabinet. The ice will need to be removed to make room for more ice. Press the ON/OFF button to
restart the ice maker after the ice has neem removed.

4
OPERATION INSTRUCTIONS
Step 1.
Open the lid and fill the water reservoir with water.
Note: Make sure the water level in the water reservoir is not over the Ice collecting tray.
Step 2.
Connect to the power.
Step 3.
Press ON/OFF button to turn unit on. The ice maker begins to work.
Note: For the first three cycles, the ice may be small and irregular in size.
Step 4.
If the ADD WATER indicator is red with an alarm sound, then take out the basket and add water as per step 1，then
press the ON/OFF button to restart the ice maker
Note: If no water is pumped up to the water tray over two cycles but the water in water tank is enough, then tilt
the unit upwards slightly, then remove the silicon stopper, and let several drops water runs out.
Step 5.
If the ICE FULL indicator is red with an alarm sound, please take out the ice with the scoop.
Note: When the ice collecting tray is full, please remove the ice immediately. Do not allow
the ice collecting tray to overfill.
Step 6.
Press ON/OFF button to stop the machine.
Step 7.
Hold the ice maker above a bucket or sink, then remove the silicon plug and drain out the water.
Remove this silicon plug and drain the water

5
CLEANING
1. Clean the inner liner, ice collecting tray, water box, ice scoop and evaporator frequently. When cleaning,
unplug the unit and remove the ice cubes. Use a diluted solution of water and vinegar to clean the inside
and the outside surface of the ice maker. Do not spray the ice maker with chemicals or diluted agents such
as acids, gasoline or oil. Rinse thoroughly before starting.
2. Keep ventilation openings in the appliance enclosure, or in the built-in structure, clear of obstruction.
3. If the icemaker is reused after a long time, the water pump may not pump enough water due to an air block,
the deficient water indicator turns on in this case. To correct this, press the ON/OFF button again, then the
icemaker will work normally.
4.To ensure the cleanliness of the ice cubes, water in the water reservoir should be replaced every 24 hours.
5.If the compressor stops for any reason such as water shortage, too much Ice, power off, etc... Do not start the
system right away, waits 3 minutes, and then re-starts the Ice maker.
6. Always use fresh water before starting ice production either at initial installation or after a long shut-off period.
7. If the unit is not used for a long time, before the use, plug the unit in and then press the ON/OFF button for 5
seconds, the unit will clean itself. All indicators will illuminate every 5 seconds, the pump till take water 5 times,
each time 30 seconds).

6
TROUBLESHOTING
1. Please note, if a power failure occurs due to disconnection of the power cord, or the off-power button has been
pushed off during an ice making cycle, small ice chips may form and lodge in the automatic shovel causing it to
jam. If this occurs, the ice chips may be removed by disconnecting the power cord and gently pushing the shovel
to the rear of the cabinet and removing the ice chips, then restarting.
2. Please restart the ice maker by pressing the ON/OFF button. If the Ice shovel does not push the ice into the ice
collector after the formed ice drops from the evaporator while at the same time the ICE light is on, check to see if
the water tray is horizontal or balanced. If not, then adjust by pressing the ice shovel lightly with your finger. Then
re-start the Ice maker.
Problem
Possible Cause
Suggested Solutions
The compressor works
abnormally with a Buzzing
Noise.
The voltage is lower than
recommended.
Stop the Ice maker and do not restart
until the voltage is normal.
Water shortage indicator
light is on.
1. There is no water.
2. The pump is full of air.
1.Press the ON/OFF button, fill with
water, wait 3 minutes and press the start
button to restart. When the water has
reached the fill line the ice maker will
restart automatically.
2.Remove the silicon stopper and let
several drops water run out.
Indicator lights on display are
not on.
Blown fuse/ No power.
Replace fuse / Turn power on
The Ice made is too large
and with pieces sticking
together.
1. Ice of previous cycles left
in the water tray.
2. The evaporator is too
low.
1. Stop the unit right away, restart the
unit when the ice in the water tray has
melted.
2. Shift the evaporator a little.
Conditions for Ice making
are right but no ice is made.
A. There is no refrigerant in
the compressor.
B. Compressor is broken
down or the fan motor is
broken.
Call for service.
The lights for ice full and add
water come at in the same
time.
Water tray is blocked by ice
cube.
Clear the ice cube under the ice shovel
pull out the plug and insert It again then
press the” ON/OFF” button, two minutes
later the machine will restart
automatically.
Machine keeps running, but
the water is warmer than the
normal water.
The magnetic valve is
broken.
Replace the magnetic valve.
Water leakage at front bottom
of the unit.
The silicon stopper is not
inserted correctly.
Please insert the silicon stopper correctly.

7
NOTES
• Fill with drinking water only.
• It is normal for the compressor and condenser surface to reach temperatures between 70°C and 90°C
during operation and surrounding areas may be very hot.
• Due to fast freezing, ice cubes may appear “Cloudy”. This is air trapped in the water and will not affect the
quality or taste of ice.
R-600a is a fluorinated greenhouse gas covered by the Kyoto Protocol; its global warming potential is 1300.
SPECIFICATIONS
Daily Ice Output: 10kg / 24 hours
Ice Storage Capacity: 600 g
Compressor High efficiency CFC free R600A
Water Reservoir Capacity: 1.7 Litres
Dimensions(W*D*H): 242 x 358 x 328 mm
Weight: 9.8 kg
Voltage: AC 220-240V/50Hz
Power: 150W
Power cord: 3 pins earthed plug. (to reduce risk of electric shock)
DISPOSAL
When your appliance reaches the end of its working life, care must be taken when disposing of this Ice Maker to
avoid a hazard. When disposing of the Ice Maker, cut off the plug so that it will render the unit unusable to avoid
electrical shock. Also contact your local council for instructions on how to safely dispose of the compressor and
refrigerant.
* This product may vary slightly to the product illustrated due to ongoing product development.