LevelOne FCS-1010 User manual

LevelOne FCS-1010
P/T IP Camera
Quick Installation Guide
System Requirements
Windows 98, 98SE, Millennium Edition (ME), 2000 and XP operating systems♦
♦
♦
PC with Pentium III 800MHz system or above is recommended
Memory Size:128MB (256 is recommended)
NOTE:
All the captured images of installation mentioned in this user’s manual
were based on Windows XP operating system. For installation on other
Windows OS, e.g. Windows 98SE, all the procedures remains the same.
1 LevelOne FCS-1010 Hardware Installation
Connect the Ethernet Cable
Please use a cross-over Ethernet cable if you connect this camera directly to a PC.
Connect an Ethernet cable to the
Ethernet connector located on
the back panel of FCS-1010.And
attach it to the newwork

Attach the External Power Supply
Attach the external
power supply to the DC
power input connecto
And connect it to an AC
power o
r.
utlet.
Attach the AV cable(optional).
Connect the AV cable only if you wish to connect FCS-1010 to a TV set.
Attach the AV cable to the
AV out connector .
Attach the yellow RCA connector to the “Video” connector on your TV.
Attach the white RCA connector to the “Audio” connector on your TV.
2

Configuring your FCS-1010 with IP Installer
Insert the FCS-1010 CD
into the CD-ROM drive.
Click on “IP Installer”.
2
IP Installer screen shall
show up.
The IP Installer will show
a MAC address and an
IP Address of available
FCS-1010.
3

Highlight the MAC
address and click “Link to
selected device”.
After successful linkage, the
authentication window should pop up.
The default user name is “root”.
The default password is the MAC
address of your own FCS-1010, which
marks at the bottom label of each
device.
Please enter the MAC address in
capital letters.
4

3 Viewing Your LevelOne FCS-1010
The following screen would appear automatically after successful login.
Click “Yes” and proceed.
.
FCS-1010 should be active by now.
It is highly recommended
that set a password for
security purposes.
Click on Configuration
for setting the password.
5

Configuration Page
This is the page where you can change the basic settings of the FCS-1010.
Click on “Security” and
set your password and
add additional accounts
to the FCS-1010
necessary.
if
The basic installation and configuration of FCS-1010, P/T IP Camera, is
now complete. Please refer to the user`s manual for further configuration.
6