LEW ELECTRIC PUFP-CT-PB Series User manual

!
!"#!$%&$!'()*+,*)(,-)&.//.&,0-(1",2*(
(
!
!+,0+(&0(,-)&.//.&,0-3(
1.!!To!ensure!compliance!with!local!electric!codes,!please!contact!your!local!
electrical!inspector!prior!to!installation!
2.!!Do!not!install!PUFP-CT!prior!to!electrical!inspector!authorization.!
3.!Installation!should!only!be!done!by!a!licensed!and!bonded!electrical!contractor.!
4.!All!power!must!be!turned!off!at!its!source!prior!to!installation.!!Failure!to!do!so!
may!result!in!injury!or!death.!
5.!All!non!GFI!PUFP-CT!series!must!be!connected!to!a!GFCI!circuit!breaker.!!Failure!
to!do!so!will!increase!the!risk!of!injury.!
6.!If!anytime!water!enters!into!the!PUFP-CT,!turn!off!power!at!its!source!and!have!
the!unit!replaced!by!a!licensed!and!bonded!electrical!contractor.!
7.!!Always!use!12!or!14!gauge!STRANDED!wire!when!possible.!!!
45((/*6(*/*%&+,%(.%%*!&)(-0(+*)!0-),',/,&7(,#(&8*(.'09*(%0-2,&,0-)(
.+*(-0&(:*&5(
!
!
+*;",+*2(&00/)3(
Crimpling!Pliers/!Wire!Strippers,!Philips!Head!Screw!Driver,!and!Drill.!
!
,-)&.//.&,0-((<!=>?(0@AB(
1.!Prior!to!installation,!a!professional!granite!cutter!should!cut!a!4!1/8”!x!4!1/8”!hole!
in!the!desired!location!of!the!PUFP-CT.!**"NOTE:"When"choosing"a"location,"there"must"be"a"
minimum"of"1"inch"of"unobstructed"clearance"around"each"side"of"the"hole"inside"the"cabinet"to"allow"
the"locking"ring"to"screw"onto"the"box.
2.!Always!use!the!supplied!PUFP-PB!plastic!box.!!Unscrew!the!locking!nut!from!the!
bottom!of!the!box!and!set!aside.!!
3.!!Wiring!must!be!completed!before!PUFP-PB!is!installed!in!countertop.!!Place!
PUFP-PB!box!on!top!of!countertop.!!Inside!the!cabinet,!place!the!lock!nut!through!the!
wire.!!Run!wiring!into!the!½”!knock!out!on!the!side!of!the!box!furthest!away!from!
the!front!of!the!countertop!(preferred!method).!!Alternately,!if!¾”!knockouts!are!
needed,!use!the!knockouts!in!the!bottom!of!the!box!furthest!away!from!the!front!of!
the!counter.!!,C(?DA(E@FGEFH?I(=>A(HIAJ(GKFIAI?(?F(?DA(C>F@?(FC(?DA(GFH@?A>L(?DA(
H@M?(NMKK(@F?(FOA@5(
4.!Strip!the!wires.!
5.!Insert!the!stripped!wire!into!the!quick!connect!terminal!box!making!sure!that!no!
striped!wire!is!exposed.!

6.!Tighten!the!screws!to!secure!the!wires!to!the!terminal!block,!part!number!PUFP-
TN.!
7.!Excess!wire!should!be!pushed!out!of!the!box!or!made!to!be!as!flat!as!possible!on!
the!bottom!of!the!PUFP-PB!box.!!#=MKH>A(?F(OHID(?DA(NM>A(FH?(FC(?DA(PFQ(F>(R=EA(
M?(CK=?(M@(?DA(PFQ(NMKK(M@?A>CA>A(NM?D(?DA(FOA@M@S(RAGD=@MIR(=@J(?DA(H@M?(NMKK(
@F?(PA(=PKA(?F(OFO(FOA@5(
8.(Remove!the!protective!film!from!the!PUFP-CT!cover!and!press!the!oval!button!on!
the!PUFP-CT!cover!exposing!the!two!mounting!screw!holes!inside!the!cover.!
9.!Place!the!PUFP-CT!cover!on!top!of!the!PUFP-PB!box.!!Line!up!the!two!screw!holes!
with!the!PUFP-CT!cover!and!the!PUFP-PB!box!and!using!the!2!provided!screws,!
secure!the!cover!to!the!box!(do!not!over!tighten!as!this!may!strip!the!threads!in!the!
box!and!interfere!with!the!opening!mechanism!of!the!box.)!
9.!!Place!the!box!with!cover!assembled!into!the!hole!in!the!top!of!the!countertop.!
10.!!Place!the!locking!ring!onto!the!bottom!of!the!PUFP-PB!box!and!screw!the!locking!
ring!up!until!the!flanged!portion!is!butted!tight!against!the!underside!of!the!counter!
top.!!!The!box!is!fully!secured!to!the!counter!top!when!there!is!no!movement!of!the!
box!within!the!hole.!!!
!
!
,-)&.//.&,0-((<!=>?(&NFB(
1.!To!close!the!cover,!press!and!hold!the!open!tab!while!pressing!down!on!the!cover!
until!you!hear!a!click!and!the!unit!is!locked!into!place.!
2.!Open!and!close!the!unit!several!times!to!make!sure!that!the!unit!is!opening!
properly!and!at!the!desired!speed.!!All!units!are!preset!to!the!optimal!functioning!
speed!at!the!factory!before!they!are!shipped.!
!
(
!
IMPORTANT)ADDITIONAL)SAFETY))NOTICE)))))))))))))Avis%%important%%relatif%%à%%la%%securite)
￭
Never use in overload situation, or it may increase the risk of catching a fire.
Ne jamais utiliser en situation de surcharge, ou cela peut augmenter le risque de provoquer un incendie.
￭ Make sure that all bare wire is connected deeply and securely into the terminal(see diagram).Failure to do so will
increase the risk of fire.
Veiller à ce que tous les fils nus solent connécte profondément et solidement dans le bornier (voir schéma).
A défaut, cela augmente le risque d!"#$%#&"%'
￭
Once the wiring connections are made wrap the connections with U.L. approved electrical tape. Failure to do so will
increase the risk of causing a fire.
Une fois les branchements faits, enrouler de l'adhésif ()*++,'-'.(/01/*.&%2.$1##%3"1#2'..
4.&+&(/05.$%6(.(/)7%#0%.6%.*"28/%.&%.9*1:18/%*./#."#$%#&"%'.
￭!The!products!should!be!installed!by!a!licensed!and!bonded!electrical!contractor!according!to!related!
Canadian!Electrical!Code.!
-%2.9*1&/"02.&1":%#0.;0*%."#20(66+2.9(*./#.+6%$0*"$"%#.()*++.%0.6"+.2%61#.6%.<1&%.+6%$0*"8/%.$(#(&"%#.%#.*(991*0.
￭!Never!use!a!wiring!device!other!than!the!U.L.listed!wiring!device!provided.!
=%.>(7("2./0"6"2%*./#.&"2912"0":%.&%.$?@6()%.(/0*%.8/%.6%.&"2912"0":%.&%.$?@6()%.()*++.,'-'.A1/*#"'..
!