Lexicon DC-2 User manual

Lexicon Part # 070-13228 Rev 1 © 1999 Lexicon, Inc.
DC-2 Digital Controller Quick Reference Guide
Finding your way through the Menus
Continue highlighting and
SELECTing to reach the
parameter you want to
change.
Press DONE to step back
and exit each display.
Adjust parameters with ▲
or ▼. Your changes are
saved automatically.
On the remote control,
press SELECT.
Use ▲or ▼tohighlight an
item. Press SELECT to
open a submenu.
Lexicon, Inc. 3 Oak Park • Bedford MA 01730-1441 USA • Tel: [phone] • Fax: [phone] • www. lexicon.com

Lexicon Part # 070-13228 Rev 1
© 1999 Lexicon, Inc
DC-2 Digital Controller Quick Reference Guide
Zone2controlscanbeaccessedfromeithertheDC-2front
panel, ortheremotecontrolbypressing andholdingdown
the Record/Zone 2 button in conjunction with the buttons
shown below.
Record/Zone 2 ControlAlternate Remote Control Functions
Restoring Factory Defaults
When the message:
FACTORY PRESETS MENU
FACTORY DEFAULTS
RESTORED
isdisplayed,pressDONEto
return to normal operation.
Makeanoteofanyprograms,setuporcalibration
valuesyouwanttore-enter,asthisprocedurewill
reset all DC-2 parameters to their default states.
as well as all setup and calibration values.
Lexicon, Inc. 3 Oak Park • Bedford MA 01730-1441 USA • Tel: [phone] • Fax: [phone] • www. lexicon.com
Using the remote, turn the
unit OFF, then ON, then
pressandholdMUTE. The
on-screen display will
read:
To resume normal opera-
tionwithout restoringallde-
faults, press SELECT.
To clear and reload all pre-
set effects and all factory
settings, use ▼to highlight
RESTORE DEFAULTS,
and press SELECT.
FACTORY PRESETS MENU
EXIT
RESTORE DEFAULTS