6
ENGLISH
INSTALLATION
This appliance contains a
small amount of isobutane
refrigerant (R600a), natural gas
with high environmental compat-
ibility, but it is also combustible.
When transporting and installing
the appliance, care should be
taken to ensure that no parts of
the refrigerating circuit are dam-
aged. Refrigerant squirting out of
the pipes could ignite or cause an
eye injury. If a leak is detected,
avoid any naked ames or poten-
tial sources of ignition and air the
room in which the appliance is
standing for several minutes.
In order to avoid the creation of a
ammable gas air mixture if a leak
in the refrigerating circuit occurs,
the size of the room in which the
appliance may be sited depends
on the amount of refrigerant used.
The room must be 1m2in size for
every 8g of R600a refrigerant
inside the appliance. The amount
of refrigerant in your particular
appliance is shown on the identi-
cation plate inside the appliance.
Never start up an appliance show-
ing any signs of damage. If in
doubt, consult your dealer.
Installation
1. Select a good location. Place your fridge-freez-
er where it is easy to use.
2. Avoid placing the unit near heat sources, direct
sunlight or moisture.
3. To ensure proper air circulation around the
fridge-freezer, please maintain sucient space
on both the sides as well as top and maintain
at least 2 inches (5cm) from the rear wall.
4. To avoid vibration, the unit must be leveled. If
required, adjust the leveling screws to compen-
sate for the uneven oor.
The front should be slightly higher than the
rear to aid in door closing. Leveling screws can
be turned easily by tipping the cabinet slightly.
Turn the leveling screws counterclockwise ( )
to raise the unit, clockwise ( ) to lower it.
5. Clean your fridge-freezer thoroughly and wipe
o all dust accumulated during shipping.
6. Install accessories such as ice cube box, etc., in
their proper places. They are packed together
to prevent possible damage during shipment.
7. Connect the power supply cord (or plug) to the
outlet. Don’t double up with other appliances
on the same outlet.
Appliance Usage Range
This appliance is intended to be used in household
and similar applications such as:
• sta kitchen areas in shops, oces and other
working environments;
• farm houses and by clients in hotels, motels
and other residential type environments;
• bed and breakfast type environments;
• catering and similar non-retail applications
Starting
When your fridge-freezer is installed, allow it 2-3
hours to stabilize at normal operating temperature
prior to lling it with fresh or frozen foods. If power
plug is disconnected, allow 5 minutes delay before
restarting. Your fridge-freezer is now ready for use.
