LG Twin Wash System User manual

LG Product Installation
Pedestal Washer
Washer

LG Product Installation
DON’T place product
upside down
- Twin Wash (Pedestal Washer)
Drawer damage
Control panel damage
Side
Top
Bottom
Sliding door damage (some
models)
Inner Tub assembly
damage
DON’T lay down on side wall

LG Product Installation
- Twin Wash (Pedestal Washer)
Remove blue inner packing
from Tub and discard
Remove
Remove packing material
(foam)
Rotate cover 180º and secure
with provided screws
To prevent scratches, PRIOR to installing the FLW:
Remove blue tape Adhere tape to the
edges and drawer to
prevent scratches or
the drawer opening.
①
②

LG Product Installation
Using the wrench
provided make sure
the legs of the FLW
are fully retracted
and level prior to
mounting
- Twin Wash (Pedestal Washer)- Installing the Front Load Washer
Align and set down the main washer to
the holes at each corner of the unit.
Make sure actuator of washer sits on
correct position, depressing the contact
on the Sidekick
Secure FLW to Sidekick
with 16 screws provided.
Not using all screws can
cause noise and vibration
issues.
Adjust the legs of the flw and
Sidekick.
Then adjust the lock nuts toward
the washer and pedestal

LG Product Installation
- Twin Wash (Pedestal Washer) –Water Hook Up
Remove film from lid
main washer
SideKick
Attach 2 short hoses included in the
Installation kit to the faucets.
Red for Hot / Blue for Cold
Connect the long hoses to
the back of the main washer
Then connect the other 2
hoses to the back of the
SideKick
Connect main wash hoses to Y
connector.
Connect SideKick hoses to the
other side of the Y connectors.
Once all hoses connected make
sure they are all tighten

LG Product Installation
- Twin Wash (Pedestal Washer)
Place wide clamp supplied
with installation kit around
end of Drain Hose.
Connect drain hose to
SideKick making sure it points
up
Connect drain hoses to Y drain hose
connector. Use clamps provided to
secure them.
The end of the Y drain hose
connector is then inserted in the
stand pipe
Secure hoses together with supplied tie straps
Turn water on and check all connections.
Place unit in final position.
Level units
Tripod water level device