LIGHTINC UPFOGGER 1500 RGB User manual

Thank you for buying the Light-inc UPFOGGER 1500 RGB. For your own
safety, please read this user manual carefully before installing the device.
When receiving the machine, open the package and check carefully whether
the machine is damaged or the accessories are lost, if any problems, please
contact the supplier.
Technical Parameters
Power: 1500W
Voltage: AC 230V 50Hz
Control mode: LCD display, DMX 512, wireless remote control
Warm-up time: 3 minutes
Capacity of tank: 2 liters
Fluid consumption (100% output): 18000 Cu. ft/min
Smoke distance: 6-8 meters
Weight: 12.3kgs
Guidance ………………………………………………………■
1. This product can be installed upwards or placed on the ground.
2. Keep the fog machine flat, do not tilt or flip. Before connecting this unit to
the mains power supply, you must add the fluid tank with high quality fog
fluid and check that the nozzle is clean and unobstructed.
3. Before connect to power, you should check whether the voltage you use is
suitable for the fog machine or not.
4. Power cord should be plugged in to a grounded electrical outlet and put the
switch to “ON”. Then the fog machine starts warming up and you can spray
fog after warming up is completed.
Control Mode………………………………………………■
1. Remote control key functions:
Button A: Fog + 100% Red Button C: Fog + 100% Blue
Button B: Fog + 100% Red + 40% Blue Button D: Fog + 100% Red + 40% Green
2. DMX control: 7 DMX channels.
CH1: Smoke output CH2: red light CH3: green light CH4: blue light
CH5: LED strobe CH6: built-in program CH7: built-in program speed
3. LCD display
Button
Function
FUNCTION
UP
DOWN
TIMER
VOLUME
MANUAL
Enters the programming mode
Value adjustment upward
Value adjustment downward
Starts the timer controlled operation
Starts or stops all operation
Press and hold for manual fog output
Interval 1——200 Pause time between timed output
Duration 1——200 Duration time of timed operation
DMX512 1——512 Set the starting DMX address
Volume 1——100 Set the volume output
Red 0——255 Green 0——255
Blue 0——255 Glint 0——255
Skip 0——255 Gradual 0——255
Notice 1………………………………………………………■
1. This fog machine should be used in dry and well-ventilated place.
Please avoid any water or rain fall in the machines, if water or rain falls
in, turn off the power immediately. The distance to another object should
be at least 30cm. Keep far away from children, fire, explosive and
flammable things.
2. When the fog fluid is running out, add fog fluid in time. If the fog
machine is out of fluid, the pump and other parts will get damaged.
When adding fluid, remember to turn off the power and carefully avoid
spilling over.
3. The fog machine should work under professional worker’s super
vision, please do not add flammable liquids, gas or perfume into the fog
fluid tank.
4. All fog machine will have condensation or moisture around the nozzle.
5. All fog machine have cycles and temperature cooling to a point, the
pump will automatically turn on and begin heating, until heating
complete, the machine starts to spray smoke.

Routine Maintenance and common faults ………………………■
Periodically clean your machine to reduce replacement or repair costs.
The machine can be blocked due to high concentration fluid, bad quality fluid
or overheat, so regular care and maintenance can ensure long lifetime. After
about 20 hours use, please use 80% distilled water and 20% white vinegar to
remove the accumulated impurities inside the heat pipe, as following:
1）Clean the pipe in the tank and the filter head.
2）Take out the fog liquid and use the cleaning liquid (80% distilled water
and 20% white vinegar) to clean the machine. Keep it operating till the
cleaning liquid runs out.
If the fog turns less, the pump starts making noise, or the fog completely
stops, you should turn off the power immediately and check the fluid tank,
fuse, controller interface and power. If all of these are normal and the
problems still occurs, please contact your supplier.
UPFOGGER 1500 RGB
MANUAL