Lightmaxx VEGA ARC Pro II User manual

ENGLISH
Important safety instructions! Please read before connection!
DANGER! (Electrical shock due to high voltages in the device)
The housing must not be removed! There are no parts to be maintained in the device.
Inside the unit there are components which are under high electrical voltage.
Before each use, check the device for damage or the absence of components, protective
devices or housing parts. If this is the case, the device must not be used!
Leave maintenance and repair work to a qualified service workshop or contact your
dealer. In the case of a malfunction of the device, operation must also be stopped
immediately until the device has been repaired by a specialist!
DANGER! (Electric shock due to short circuit)
Modifications to the power cord or plug are prohibited. If the power cord is damaged, it
must be replaced immediately with an original spare part from the manufacturer. Failure to
do so may result in fire or death due to electric shock!
DANGER! (For babies and children)
Dispose of or store any packaging material properly! Packaging material must be kept out
of the reach of babies and children due to the risk of suffocation.
Ensure that children never use the appliance unattended! In addition, make sure that
children do not remove (small) parts from the device, as they could suffocate by swallowing
parts!
WARNING! (High light intensity - eye injuries)
A direct view into the light source is absolutely to be omitted!
WARNING! (Epilepsy)
Stroboscopic effects (flashes of light) can trigger seizures of epilepsy in some people.
Accordingly sensitive people should be warned and should not be in the vicinity of such
devices.

ENGLISH
Hint! (Fire hazard due to overheating)
The maximum permissible ambient temperature of this device is 40°C.
The device can reach a temperature of up to 85° on the surface after several hours of
use. Ensure that the unit is placed in a well-ventilated location away from direct heat
sources, naked flames, combustible materials, and liquids. A minimum distance of 1 m is
required.
Do not tape or cover the ventilation slots of the unit.
Hint! (Operating conditions)
In accordance with DIN EN 60529, the protection class designation IP (International
Protection) is appended to 2 code numbers. The 1st code number stands for the extent of
protection of a housing against foreign bodies and contact. The 2nd code number, on the
other hand, describes the scope of protection against the ingress of water.
This device is classified as IP65.
1st code number of the IP code: Devices with protection class IP65 are dustproof and
completely protected against contact.
2nd code number of the IP code: In addition, the devices are protected against water
jets from any angle, so that these devices can also be used outdoors.
However, event technology devices are only suitable for temporary use.
Continuous outdoor operation is not recommended!
Hint! (Power supply)
It is essential that you check that the device voltage matches your local mains voltage. It
is highly recommended that you fuse your mains socket with a residual current circuit
breaker (FI).
If you do not use your device for a longer period of time or carry out maintenance work,
disconnect the device from the mains in order to minimize danger. The same applies to
storm conditions such as thunderstorms, floods, etc.
Hint! (Error during data transmission)
Never connect the DMX input or output to audio devices such as power amplifiers or
mixing consoles!
DMX cables enable trouble-free operation and the highest possible transmission reliability
of signal data. Do not use microphone cables!

ENGLISH
Hint! (Condensation)
To avoid condensation in the unit, the unit should adapt to the ambient temperature
before commissioning.
Hint! (Unwanted odours)
A new product can sometimes lead to unwanted odours. This reaction is normal and
disappears after a few minutes.

ENGLISH
Symbols on device and packaging:
The lightning flash symbol warns the user of uninsulated voltages and the risk
of electric shock.
The exclamation mark symbol draws the user’s attention to important maintains
and operating instructions in the manual.
This symbol defines the minimum distance of the object to be illuminated.
Read the manual
Please read and follow the warnings and recommendations carefully to ensure safe
and trouble-free use.
Installation:
Be sure to check the unit for damage before use. Use the original packaging or a suitable
transport or storage packaging to protect the product from dust, moisture, etc. when not in use.
The unit can be installed either upright or suspended. The device must always be attached to a
solid, approved carrier or a suitable surface. Note the load limit of the selected installation
position (e.g. for tripods).
The opening of the bracket must be used to fasten the device. Always provide a second,
independent safety backup for the device, e.g. with a safety cable.
Work on the device (e.g. assembly) should always be carried out from a stable and permissible
platform. Make sure that the area below you is closed off.
WARNING! (Risk of injury due to falling down)
Improper installation can cause considerable injury and damage!
The installation of the device should always be carried out by experienced personnel and
must be carried out in compliance with the mechanical and electrical safety regulations in
your country.
Please note that it is not possible to use this device with a dimmer!

ENGLISH
Congratulations on your new lightmaXX VEGA ARC Pro II!
Thank you for choosing a lightmaXX product. Through efficient development and economical
production, lightmaXX enables high quality products at a fantastic price.
Please read the instruction manual carefully to learn about all the features of this
product and keep it for future use.
Have fun with your new product!
Your lightmaXX Team
Guarantee:
The current general terms and guarantee conditions
of the Music Store professional GmbH apply.
You can view it at: www.musicstore.de
If you have any questions or suggestions, please
contact us:
Music Store professional GmbH
Istanbulstr. 22-26
51103 Cologne
Managing Director: Michael Sauer
WEEE-Reg.-No. DE 41617453
Tel: [phone]
Fax: [phone]
[e-mail]
Intended use:
The lightmaXX VEGA ARC Pro II was designed for use as an electronic LED lighting effect. The
device may only be used for this purpose and in accordance with the operating instructions. Other
purposes as well as operation under other operating conditions are expressly not intended and can
lead to damage to property or personal injury! No liability is assumed for damage resulting from
improper use.
It must be ensured that the device is operated exclusively by trained and competent users who are
in full possession of their mental, physical and sensory abilities. The use of other persons is
expressly only permitted at the request of a person responsible for their safety, who instructs or
supervises the use.
Content
Quantity
VEGA ARC Pro II
1
Power cable
1
DMX cable
1
Mounting bracket
1
Manual
1
Scope of delivery:

ENGLISH
Set up:
All connections of the device should be made before switching on. Only use high-quality cables
that are as short as possible for the connections.
Configuration of the DMX connector:
Resistance 120 ohm // ¼ w between pin 2 (DMX-) and pin 3 (DMX+) oft he last fixture.
Operating mode DMX:
Connect the DMX input of your device to the DMX output of your DMX controller, your DMX
software or the DMX output of a device already in your DMX line. Always use a DMX cable with a
110 Ohm resistor for this connection. Address the device according to your DMX configuration.
The following table shows the respective DMX modes of the individual devices with the
corresponding values and functions:
Channel
Value
Function
1
000-255
Master Dimmer
2
000-255
Red Dimmer
3
000-255
Green Dimmer
4
000-255
Blue Dimmer
5
000-255
White Dimmer
6
000-255
Amber Dimmer
7
000-255
UV Dimmer
8
000-255
Stroboskop
(Speed: slow to fast)
9
000-255
Makrofunction
10
000-255
Makrofunction
Setting the speed

ENGLISH
Static, Auto or Sound mode:
The device contains automatic programs that run according to fixed schemes (Auto) or are
recalled via the built-in microphone to match the music (Sound). The selection of the respective
mode takes place via the menu directly on the device.
If you connect several devices of the same type via DMX, they can be controlled simultaneously
via the master device. To do this, set the desired function "Master" on the first device of the line,
the other devices of the series must now be set as "Slave". Now the first device of the line gives
the function to all other devices and all devices run simultaneously.
Operation:
Start:
Connect the device to the mains and wait a few seconds until it is ready for operation.

ENGLISH
Connections and controls:
Menu:
Navigation in the menu is via the four menu buttons below the display. Use the "Mode" button to
activate the menu, navigate via the "Up" and "Down" buttons. A corresponding selection is
confirmed with the "Enter" key.
No.
Designation
No.
Designation
1
Locking Screw
6
Operating keys
2
Mounting Bracket
7
DMX Input (3-pole)
3
LED Lense
8
DMX Output (3-pole)
4
Cooling fin
9
Power Supply (Power Twist)
5
Display
10
Power Output (Power Twist)

ENGLISH
The menu structure in detail:
Menu
Value
Function
d001
d001-d512
Setting the DMX start address
Au01
Red
Au02
Green
Au03
Blue
Auxx
Au04
White
Au05
Amber
Au06
UV
Au07
Pink
Au08
All Colors
Au09
Color jump change
Au10
Color gradual change
S01
Sound control jump change
S02
Sound control Strobe
St00
St00
Auto master without Strobe
St01
Auto Master Strobe
(Speed: slow to fast)
SP00
SP16
Auto Master Au08, Au09, Au10
(Speed: slow to fast)
R000
r000-255
Red Dimmer
(brightness: dark to light)
G000
g000-255
Green Dimmer
(brightness: dark to light)
B000
b000-255
Blue Dimmer
(brightness: dark to light)
W000
w000-255
White Dimmer
(brightness: dark to light)
A000
a000-255
Amber Dimmer
(brightness: dark to light)
P000
p-000-255
UV Dimmer
(brightness: dark to light)

ENGLISH
Specifications:
Model
VEGA ARC Pro II
Power supply
110-240V 50/60Hz
Power consumption
280 Watts
LEDs
18 x 12 Watts
Color Mixing
RGBWA+UV
(Red –Green –Blue –White –Amber –
Ultraviolet)
Beam angle
45°
Protection class
IP65
Operating modes
Master/Slave, DMX, Stand-Alone, Sound Mode
Features
Static Colors, Color Change, Color Fade,
Dimmer and Strobe Effect
DMX Channels
10
Connections
DMX-In-/Output (3-pole) Power
Twist In-/Output
Dimensions without Bracket
(L x W x H)
240 x 240 x 255 mm
Dimensions with Bracket
(L x W x H)
260 x 260 x 275 mm
Weight
5,5 kg

ENGLISH
Troubleshooting:
The following overview serves as an aid for quick troubleshooting. If you are unsure, contact the
manufacturer, the dealer or the corresponding specialist personnel. Never open the device on
your own!
If the specified corrections have not led to success, please contact our service staff. The contact
details can be found at www.musicstore.de
Cleaning:
Regular cleaning of the device from dirt and dust increases the shelf life of the product. Always
disconnect the device from the power supply before cleaning it! Never clean the appliance wet!
Optical lenses should be cleaned with a dry microfiber cloth to optimize light output. Ventilation
grilles and openings should always be cleaned of dust and dirt. Suitable compressed air sprays
are recommended for this application.
Symptom
Troubleshooting
No function
Check the mains connection and the fuse
No reaction in DMX mode
Check the cable connections
Check your DMX address setting
If available, try an alternative DMX controller
No reaction in remote mode
Change the battery in your remote control
Ensure that the IR transmitter and receiver are at
close and clear distances from each other

ENGLISH
Environmental protection:
The company MUSIC STORE professional GmbH always strives to reduce the burden of packaging
to a minimum. The use of environmentally friendly and recyclable materials is of fundamental
importance to us. Please dispose of and recycle the packaging components after use properly.
Disposal of packaging:
Ensure that paper packaging, plastic materials, etc. are separately recycled. Observe the
corresponding disposal instructions on the packaging.
Disposal of batteries:
Batteries do not belong in the garbage! Please keep batteries in accordance with the
official collection points or disposal stations in accordance with the specifications.
Disposal of your old device:
Do not dispose of the device with household waste! This device is subject to the WEEE
Directive (Waste Electrical and Electronic Equipment) in its currently valid version.
The device will be disposed of by an approved waste disposal company or your local waste
disposal office. The regulations valid in your country must be observed!
Manufacturer: MUSIC STORE professional GmbH,
Istanbulstraße 22-26,
51103 Cologne, Germany

ENGLISH
MS ID: LIG0017261-000
08/2021
Notes