Lightolier FIXTURE SH20330 Guide

525 Education Road, Cornwall K6H 6C7
Tel:[phone] Fax:[phone]
Page 1
Rev.01
READ AND UNDERSTAND THESE INSTRUCTIONS BEFORE INSTALLING FIXTURE
INSTRUCTIONS FOR INSTALLATION OF AGILI-T FIXTURES
This fixture is intended for installation in accordance with the National Code and local regulations.
To assure full compliance with local codes and regulations, check with your local electrical inspector
before installation. To prevent electrical shock, turn off electricity at fuse box before proceeding.
Retain these instructions for maintenance reference.
INSTRUCTION SHEET NO.
SH20330
Page 1 0f 2
1. Install mounting clip on T-Bar (Figure 1) and insert canopy onto suspension kit (Figure
2). Fasten Power Feed Suspension Kit or regular Suspension Kit to 1/4-20 screw
provided (Figure 2). Attach clips to upper deck when required by local code by inserting
support to building structure through the supplied holes (Figure 3).
T-Bar
Mounting Clip
Suspension Kit
Support to Building
Structure
Figure 1 Figure 2
Figure 3
Figure 4
Aluminum
Joiner
Power Feed
Connection
2. Install luminaire temporarily by inserting die-cast aluminum joiner mechanism at the end of aircraft cables (Figure 5).
into plastic end cap of fixture (Figure 4). Manually plug in power feed connection (plus 2 extra communication cables for
Agili-T Network) when installing single luminare or first of a row (Figure 5).
3. Adjust height using aircraft cable plunger mechanism (Figure 5). Adjust level by sliding Aluminum Joiner sideways as
needed (Figure 4). Final level adjustment can be performed before or after installing end-cap or next luminaire in a row.
Plunger
Mechanism
Figure 5
Aircraft Cable
Canopy
1/4-20 Screw
Plastic End Cap

525 Education Road, Cornwall K6H 6C7
Tel:[phone] Fax:[phone]
Page 2
Rev.01
READ AND UNDERSTAND THESE INSTRUCTIONS BEFORE INSTALLING FIXTURE
INSTRUCTIONS FOR INSTALLATION OF AGILI-T FIXTURES
This fixture is intended for installation in accordance with the National Code and local regulations.
To assure full compliance with local codes and regulations, check with your local electrical inspector
before installation. To prevent electrical shock, turn off electricity at fuse box before proceeding.
Retain these instructions for maintenance reference.
INSTRUCTION SHEET NO.
SH20330
Page 2 0f 2
4. Place end-caps at luminaire extremities (Figure 6)
or connect next luminaire in row (Figure 7).
5. Secure end-caps or next luminaire in row by
tightnening two screw wedges (Figure 6-7) of
aluminum joiner (Figure 4).
End-Caps
Luminaire 1 Luminaire 2
Figure 6
Figure 7
Screw Wedge
Screw Wedge
6. Locate Junction Box on mounting clip using lancings (Figure
8) and secure from inside with #8 screw provided. Pull power
feed wire through bushing into J-Box, secure with strain relief
and make electrical connections (Figure 9).
7. Install J-Box cover using #8 screw provided and secure J-Box
to building structure as per local building codes (Figure 10).
8. Notch (1-1/2" x 1-1/2" max) and place tile (Figure 11).
9. Secure canopy using set screw provided (Figure 11).
#8 Screw
J-Box Cover
Mounting Clip Strain Relief
Figure 8
Figure 9
Lancing
#8 Screw
Junction Box
Set Screw
Support to Building
Structure
Figure 10
Figure 11
Canopy
Bushing
Power Feed
Tile