modway EEI-3367 User manual

Chair
2 Front Leg x2 3 Back Leg x2

Chair
Chair
Chair
Chair
Chair
3
2
3
2
A
A
B
C
B
C
Position one of Front Legs (2) at the corresponding wooden corner as shown.
Insert 2 pieces of Bolts (A) with 2 pieces of Plastic Washers (B) into the pre-drilled holes on the apron
of Chair Body (1) through the pre-drilled holes on Front Legs (2).
Repeat the same steps for the remaining Front Leg (2) and Back Legs (3).
Use Allen Wrench (C) to tighten all the Bolts (A) clockwise as shown, but do not fully tighten Bolts (A)
for either leg at this step.

Carefully turn over the assembled Chair.
Please put a heavy object or seat one adult on the top of the Chair Body (1) to pressure the chair for
leveling all legs. Fully tighten the Bolts (A) with Allen Wrench (C).
Close the Velcro on bottom of Chair Body (1).