Lightolier KUBIK LIGHT LINEAR FLUORESCENT LUMINAIRE Guide

INSTRUCTION SHEETINSTRUCTION SHEET
INSTRUCTION SHEETINSTRUCTION SHEET
INSTRUCTION SHEET 04-05/Rev-03 IS:SL110A
INSTRUCTION FOR INSTALLATION KUBIK LIGHT
LINEAR FLUORESCENT LUMINAIRE
A. POWER SUPPLY:
1. Follow the instructions sheet on the appropriate power
supply. (See series ISSL003)
B. COVER: (if required)
1. Carefully pull the lamp holder housing out from the
channel. (Fig.1)
2. Insert the end of a small slot screwdriver into the slot.
(Fig.2)
3. Lift the cover gently all along the channel. (Fig.2)
4. Ajust ball plunger pressure as needed. (Fig.4)
To reinstall the cover
1. Align one end of the cover with the block in the channel.
(Fig.3)
2. Press the cover along the length of channel. (Fig.3)
C. DIRECTION:
1. Follow the instructions Sheet No. ISSL003H.
D. LAMP:
(does not apply to the extended blank model no. SL003F)
2" and 2-3/4" model
1. Carefully pull the lamp holder housing out of the channel.
(Fig.1)
2. Align the pins of the lamp with the lamp holder(s), and
push in until they click. (Fig.5)
13-7/8" model
1. Align the pins of the lamp with the lamp holder, and push
in until they click. (Fig.6)
2. Gently push the stem outward and align the of the lamp
with the lamp holder, and push together until they
click. (Fig.6)
Linear fluorescent lamp T5 miniature, BI-PIN base
LAMP
HOLDER
FIG.1
CHANNEL
FIG.2
COVER
SCREWDRIVER
CHANNEL
SLOT
COVER
CHANNEL
BLOCK
FIG.3
LAMP
HOLDER
PINS LAMP
LAMP
HOLDER
STEM
PINS LAMP
LAMPHOLDER
FIG.5
FIG.6
BLANKEXTENSION
BALL
LOCK
FIG.4