Lightolier Lighting Systems LSB-8 User manual

Job Information Type:
Job Name:
Cat. No.:
Lamp(s):
Notes:
"JSQPSU3PBE'BMM3JWFS."tt'BY
We reserve the right to change details of design, materials and finish.
XXXMJHIUPMJFSDPN½1IJMJQT(SPVQt
Lighting Systems LSB-8
1BHFPG -ZUFTQSFBEÜ-4#1JFSDFE-VNJOPVT*OEJSFDU-JHIU51FS'PPU/PNJOBM4FDUJPO
#
Features
1. Housing: Extruded aluminum. Die-cast end cap mechanically attached with
no exposed fasteners or hardware.
2. Lamping:
3. Reflector: Precision die-formed semi-specular aluminum.
4. Shielding: Precision die-formed, pierced 20 gauge CRS. Piercing is four rows
that extend the entire length of the lamps. The pattern is 5/8” (1.59cm) x 1/16”
(0.16cm) slot with a 3/16” (0.48cm) separation between rows.
Electrical
Ballast is <10% THD, .98 ballast factor, pre-heat start. 18 gauge wire. Color-
coded quick connectors allow ease of connection for joiner modules. Power feed
is 18 gauge white SJT. For special circuiting consult factory. Factory installed
ballast disconnect allows the ballast to be disconnected fromand reconnected to
incoming power under load without turning the entire circuit off.
Dimming: 120/277 VAC 1% dimming level, 4 wire feed required.
Emergency Battery Pack: 28 watt: 520 lumens @ 90 minutes, 54 watt: 700
lumens @ 90 minutes, 4 wire feed required.
Mountings
Finish
Powder coated baked white or aluminumfinish. Customcolors available, consult
factory.
Labels
UL, cUL and I.B.E.W.
Ordering Instructions
Individual Fixtures:
1. Order number of MODULES required.
2. Order one POWER FEED END SET per MODULE.
Continuous Rows:
1. Determine run length.
2. Order the appropriate number of MODULES for the complete run.
3. Order one POWER FEED END SET per run.
4. Order one CABLE ASSEMBLY per MODULE minus one per run.
5. For runs that exceed amperage limits, order the appropriate number of
CABLE/CORD ASSEMBLIES.
Options and Accessories
Emergency Circuiting; special circuiting; X, T & L joiner blocks - consult factory.
Complete ordering instructions below.
Cable suspension (not shown) - 4-1/2" (11.43cm) diameter canopy finished white
enamel, 1/16" (0.16cm) diameter stainless steel aircraft cable adjustable up to 36"
(91.44cm). Dual-screw draw-tight connector to create hairline seambetween joiner
modules.
Ordering Information
Family Lamps Voltage Finish
2= 2-Lamp T8 B= Pierced AL = Aluminum
WH = White
LSB 2 B
Length Shielding Ballast
1 = 120 volt
2 = 277 volt
32 = 32W T8
3E = 32W T8 Emergency Pack
3D = 32W T8 Dimming
Two T8 32 watt fluorescent lamps per 4-Foot section.
Provided by others.
4= 4-Foot
8= 8-Foot
Pierce Pattern
3/16"
(0.48cm)
5/8"
(1.59cm)
3-1/16"
(7.78cm)
1/16"
(0.16cm)
13 4Fixture Shown Half Scale
2
3-1/2" (8.89cm)
8-1/2” (21.59cm)
1-3/4" (4.45cm)

Job Information Type:
"JSQPSU3PBE'BMM3JWFS."tt'BY
We reserve the right to change details of design, materials and finish.
XXXMJHIUPMJFSDPN½1IJMJQT(SPVQt
Lighting Systems LSB-8
1BHFPG -ZUFTQSFBEÜ-4#1JFSDFE-VNJOPVT*OEJSFDU-JHIU51FS'PPU/PNJOBM4FDUJPO
#
Performance
CANDLEPOWER CURVE CANDLEPOWER
ZONE 0 22 45 67 90
DEG.
CANDELAS
180 1100 1100 1100 1100 1100
175 1099 1097 1101 1101 1101
165 1058 1063 1074 1087 1077
155 984 995 1026 1070 1084
145 858 891 964 1061 1096
135 698 753 893 1047 1099
125 554 638 867 1079 1081
115 372 520 780 915 941
105 192 388 518 507 494
95 45 108 105 83 86
90 4 13 19 13 10
85 8 15 15 15 18
75 28 32 34 42 48
65 49 55 64 74 78
55 100 101 113 123 125
45 123 125 134 141 142
35 159 158 161 169 171
25 181 181 181 183 183
15 195 195 197 195 193
5 204 203 205 204 204
0 203 203 203 203 203
REPORT NO: LRL 300-1S
CAT NO: LSB24B32
LAMPS: 2 F32T8
LUMENS: 2900
EFFICIENCY: 83%
COEFFICIENTS OF UTILIZATION
% EFFECTIVE CEILING CAVITY
REFLECTANCE
80 70 50
WALL REFLECTANCE
70 50 30 70 50 30 50 30 10
0818181717171525252
1747168656259454442
2686257595450403735
3625449544843353230
4564842494237312825
5524336453732282421
6473832413328252118
7433428383025221916
8403124352722201614
9372822322419181512
10 34 25 19 30 22 17 16 13 11
20% FLOOR CAVITY REFLECTANCE
DISTRIBUTION
Zone Lumens % Lamp % Luminaire
0-90 584 10.1 12.1
90-180 4231 73.0 87.9
0-180 4815 83.0 100.0
Calculations are for 28 watt T5 lamps, for 54 watt T5 lamps multiply by 1.7
Fixture Lengths & Mounting Locations
48"
(121.92cm)
4' 5-1/8"
(134.94cm)
96" (243.84cm)
8' 5-1/8" (256.86cm)
96" (243.84cm)
96" (243.84cm)
96" (243.84cm)
96" (243.84cm) 96" (243.84cm)
96" (243.84cm) 96" (243.84cm) 96" (243.84cm)
48"
(121.92cm)
48"
(121.92cm)
12' 5-1/8" (378.78cm)
16' 5-1/8" (500.70cm)
20' 5-1/8" (622.62cm)
24' 5-1/8" (744.54cm)
4-Foot 8-Foot
12-Foot
16-Foot
20-Foot
24-Foot
Mounting Accessories
Power Feed End Set
Straight Cord: LSBEC36WH (white)
LSBEC36AL (aluminum)
4 Wire Cord*: LSBEC36WHX4 (white)
LSBEC36ALX4 (aluminum)
Cable Assembly
Single Cable: LSBC36
Ceiling Grid Kit
CGK
Includes both Standard 1” (2.54cm)
Tee Bar Clip & Slot Tee Clip
*Use for dimming, switching, and emergency battery packs.
Cable/Cord Assembly
Single Cable & Cord: LSBCC36
Single Cable & 4 Wire Cord*: LSBCC36X4
4-Foot
Module
8-Foot
Module
Cable/
Assembly
Power Feed
End Set
4-Foot Run 11
8-Foot Run 11
12-Foot Run 11 1 1
16-Foot Run 21 1
20-Foot Run 12 2 1
24-Foot Run 32 1