Assembly instructions:
i) Lay one short leg on the floor.
ii) Insert a rung into each recess.
iii) Slide 2 stabiliser support brackets on to the bottom rung (Leg
end without additional holes) ensuring alignment with leg (fig.1)
iv) With all rungs vertical, place the other short leg on top, align and
fit into each recess.
v) Ensuring correct alignment insert M6x30 bolts and finger tighten.
vi) Carefully turn over and repeat step v on the other side.
vii) When all rungs are seated correctly tighten with the supplied
Allen key.
viii) Repeat steps I to vii with the long legs
ix) Hold up the 2 sides to form the basis of the triangle
x) Attach the 2 triangle fixing plates to either side of your formed
triangle using the male & female threads supplied –female
threads on the inside (Each short leg already has an embedded
female thread for the quick release handles)
xi) You will find the short leg now pivots. These can be secured in
place with the quick release handles
xii) When you have constructed the triangle, turn it over and fix the
stabiliser plates to the support brackets as shown (fig.2) with
the 8 supplied screws & a PZ2 screwdriver. Each screw location
has a pre-drilled hole to facilitate the attachment.
Scan QR code for an electronic copy of the assembly instructions
