Lindy 21617 User manual

© LINDY ELECTRONICS LIMITED & LINDY-ELEKTRONIK GMBH - 3rd EDITION (JULY 2012)
Tested to comply with FCC Standards
For Commercial Use Only!
It is essential that each step of this installation guide
is completed in the stated order to ensure a
successful installation.
Modular LCD Console
Quick Hardware Installation Guide
It is highly recommended that two persons carry out the installation.
1. Please check the contents of this box against the list below, before installation.
2. Before installation, make sure all peripherals and computer have been turned off.
3. The cabinet depth range must be in 570 ~ 870 mm for the 15” and 17” console or 650 ~
950 mm for the 19” console.
4. Reliable earthing of rack-mounted equipment must always be maintained. Particular
attention should be given to supply connections other than direct connections to the
branch circuit.
Hardware Installation Kits Contents:
1. Rail with front and rear brackets x 2
2. Blocker x 2
3. Screw x 2
4. Screw (length 6mm) x 6
5. Key x 2

© LINDY ELECTRONICS LIMITED & LINDY-ELEKTRONIK GMBH - 3rd EDITION (JULY 2012)
Tested to comply with FCC Standards
For Commercial Use Only!
Installation steps:
1. Adjust the rail with the rear bracket to fit your cabinet Front
Rear
2. Attach the front and rear brackets to your cabinet
Rear
Front
3. Repeat steps 1 and 2 for the other side of your cabinet
4. Slide the console along the rails until you reach the end
5. Use a screw to connect the blocker
to the rear of the console at each side
6. Install three screws (length 6mm)
to the rear of the console at each
side to complete the installation