Linksys EC2T Original operating instructions

This sheet will guide you through the basic steps needed to install this
Linksys product on your computer. If you have any problems during
installation, visit our support page at www.Linksys.com.
After physically installing the Ethernet LAN
Card in your computer, follow these instruc-
tions to install the network driver.
Windows 95
1. Start up your computer and Windows 95.
2. Slide the EthernetCard card into your
PCMCIA slot.
3. Windows 95 will automatically detect the
presence of the EthernetCard hardware in
your computer.
4. While the Update Device Driver Wizard
window is visible, put the Combo PCMCIA
EthernetCard Program Disk into drive A and
click on Next. Windows will begin searching
your drives for the correct device drivers.
5. After Windows detects the proper network
card device driver on the disk, click on the
Finish button when it appears.
Installation is complete.
If you want to share files or printers,
refer to the Windows 95 documentation.
Windows 98
1. Start up your computer and Windows 98.
2. Slide the EthernetCard card into your
PCMCIA slot.
3. Windows 98 will automatically detect the
presence of the EthernetCard hardware in
your computer and configure the proper
driver.
Installation is complete.
If you want to share files or printers,
refer to the Windows 98 documentation.
Model No.:EC2T (w/ hourglass coupler)
Combo Ethernet LAN Card
Instant Ethernet
®
Quick Installation
Making Connectivity Easier™
For Windows 95
Note: Do not click Cancel or Skip at
any time during the installation process.
Doing so will prevent your driver from
being properly installed on your PC.