Handset modes
The new Linn handset has two operating modes, Disc mode and Amp
mode.
UUNNIIDDIISSKK11..11aanndd22..11
For operating a UNIDISK 1.1 or 2.1 the handset should be in Disc mode.
●To put the handset in Disc mode, press DDVVDD.
UUNNIIDDIISSKKSSCC
For operating a UNIDISK SC the handset should be in Disc mode when you
want to use the disc keys (play, pause, skip forward, etc.) and should be in
Amp mode when you want to use the following pre-amplifier functions:
trim adjustment, balance adjustment, auxiliary source selection.
●To put the handset in Disc mode, press DDVVDD.
●To put the handset in Amp mode, press AAMMPP.
KKIISSTTOO,,KKIINNOOSSaannddEEXXOOTTIIKK
For operating a KISTO, KINOS or EXOTIK the handset should be in Amp
mode. This allows access to the functions marked in blue (Audio Adjust,
Lip Sync, etc.).
●To put the handset in Amp mode, press AAMMPP.
You may find that on occasion when using the handset that the unit does
not respond as expected. The likely reason is that the handset is in the
wrong operating mode. To correct this, simply press either the DDVVDDkey
for Disc mode, or the AAMMPPkey for Amp mode.
Changes from the Owner’s Manual
The changes between the functionality of the new Linn handset and the
instructions in the Owner’s Manual are as follows:
UUNNIIDDIISSKK11..11aanndd22..11
The AAUUDDIIOOkey on the new handset replaces the AAUUDDIIOOAADDJJUUSSTTkey.
The SSHHIIFFTTkey on the new handset replaces the PPRROOGGkey.
The DDIISSCCkey on the new handset replaces the RREEPPEEAATTkey for the
RReeppeeaattddiissccfunction.
The AA--BBkey on the new handset replaces the RREEPPEEAATTkey for the RReeppeeaatt
sseeccttiioonnfunction.
The most significant change to the operation of the UNIDISK 1.1 and 2.1 is
that the DDIISSPPkey on the new handset replaces the VVIIDDEEOOAADDJJkey. This
means that the Video Output section of the manual on page 7, should read
as follows:
VViiddeeooOOuuttppuutt
In order to set up your UNIDISK 1.1/2.1 you must first ensure that the unit
is outputting the correct video signal type for your display device.
TTooddootthhiiss::
●Press and hold DDIISSPP(display) on the handset. The current setting
for the output video format is shown on the front panel display.
To change the video format, press (left) or (right) . The options
available are PAL, NTSC, and Native (for display devices that accept
both PAL and NTSC).
