Page 9
Starting the control unit
CAUTION
The control unit can be damaged if it slips or falls over!
XMake sure that the control unit stands horizontally (handle at top).
9Control unit is connected to the mains and the water supply.
9The sawing machine is connected to the control unit.
(see «Operating instructions - Sawing machine )
9The remote control EMERGENCY STOP has been deactivated.
Starting the control unit
XMove the controls shown below on the remote controller to the 0
position.
Feed potentiometer (6)
Starter switch (5)
Feed joy stick (10)
Main motor On/Off (7)
XSwitch on the control unit using the main switch (11).
XSwitch on the radio remote controller using the starter switch (5).
–Warning lights (radio and battery) at rst show red
–An audible signal sounds simultaneously
–Indicators ash coloured
–Second audible signal sounds
–Indicators show coloured
–Warning light ashes green
XPress the remote control pulse switch (4) briefly in the ON-position.
All indicator lights except the warning lights and the group alarm on the remote
controller go off.
XPress the reset button (12) on the control unit.
XPress the remote control pulse switch (4) briefly in the ON-position.
The the control unit 'ready' lights show green.
XOpen the water valve on the system supply line.
XPress the Water On/Off switch (2) on the remote control unit to I.
–Water flows from the cutting tool
XPress the main motor On/Off switch (7) on the remote controller to position I.
–The electric motor starts if the main motor potentiometer is at the max. position.
XThe control unit has started and ready for operation.
4.2
LWSE 1200
